You have experienced a skiing accident and are trapped at the bottom of a ravine as...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
You have experienced a skiing accident and are trapped at the bottom of a ravine as shown in the figure below. Rescuers h A slope of length d makes an angle of 0 with respect to the horizontal. You are on the ground at the bottom of the slope, and the rescuers are at the top of the slope. The top of the slope is a height h above the ground. During the accident, you cut your leg and it is bleeding continuously. Rescuers have arrived at the top of the ravine. The slope down to you is very steep; it is at 0 = 71.0⁰ with respect to the horizontal. The rescuers will require safety equipment to climb down to you. They have secured a post at the top of the ravine d= 7.95 m from you, measured along the slope, and are going to send a medic down a rope tied to the post. Unfortunately, a critical and unique carabiner (a type of clip used in mountain climbing) was accidentally dropped and has slid down the slope to you. The rescuers do not have another carabiner that will work, and you don't have time for them to go back to headquarters and get another one, because of the bleeding in your leg. The rescuers call for you to project the carabiner up the hill so that it slides all the way from you to them. (a) The snow on the slope is essentially frictionless. How fast must you project it (in m/s)? (Round your answer to at least one decimal place.) m/s (b) Suppose that there is friction in the slope and that the coefficient of kinetic friction between the carabiner and the snow is 0.200. In this case, how fast must you project it (in m/s)? m/s You have experienced a skiing accident and are trapped at the bottom of a ravine as shown in the figure below. Rescuers h A slope of length d makes an angle of 0 with respect to the horizontal. You are on the ground at the bottom of the slope, and the rescuers are at the top of the slope. The top of the slope is a height h above the ground. During the accident, you cut your leg and it is bleeding continuously. Rescuers have arrived at the top of the ravine. The slope down to you is very steep; it is at 0 = 71.0⁰ with respect to the horizontal. The rescuers will require safety equipment to climb down to you. They have secured a post at the top of the ravine d= 7.95 m from you, measured along the slope, and are going to send a medic down a rope tied to the post. Unfortunately, a critical and unique carabiner (a type of clip used in mountain climbing) was accidentally dropped and has slid down the slope to you. The rescuers do not have another carabiner that will work, and you don't have time for them to go back to headquarters and get another one, because of the bleeding in your leg. The rescuers call for you to project the carabiner up the hill so that it slides all the way from you to them. (a) The snow on the slope is essentially frictionless. How fast must you project it (in m/s)? (Round your answer to at least one decimal place.) m/s (b) Suppose that there is friction in the slope and that the coefficient of kinetic friction between the carabiner and the snow is 0.200. In this case, how fast must you project it (in m/s)? m/s
Expert Answer:
Related Book For
Manufacturing Processes for Engineering Materials
ISBN: 978-0132272711
5th edition
Authors: Serope Kalpakjian, Steven Schmid
Posted Date:
Students also viewed these physics questions
-
A cast-steel C frame as shown in the figure has a rectangular cross section of 1 in by 1.6 in, with a 0.4-in-radius semicircular notch on both sides that forms midflank fluting as shown. Estimate A,...
-
At the bottom of an 80-ft-wide spillway is a horizontal hydraulic jump with water depths 1 ft upstream and 10 ft downstream. Estimate (a) The flow rate; and (b) The horsepower dissipated.
-
A cast-steel C frame as shown in the figure has a rectangular cross section of 1.25 in by 2 in, with a 0.5-in-radius semicircular notch on both sides that forms midflank fluting as shown. Estimate A,...
-
XYZ purchased an equipment worth of $150,000 including insurance cost $30,000 and duty cost $20,000 on May 15, 2018. They have decided to capitalize the $35,000 installation charge instead of $20,000...
-
Claras utility function is U(X, Y) = (X + 2) (Y + 1), where X is her consumption of good X and Y is her consumption of good Y. (a) Write an equation for Claras indifference curve that goes through...
-
Determine the income under Division B according to section 3, after filing any necessary amended returns for each of the years indicated above. (For the purposes of this type of problem, dealing with...
-
Inventory Costing and LCNRV} Ortman Enterprises sells a chemical used in various manufacturing processes. On January 1, 2018, Ortman had 5,000,000 litres on hand, for which it had paid \(\$ 0.50\)...
-
Zobell Corporation sells equipment with a book value of $8,000, receiving a non-interest-bearing note due in three years with a face amount of $10,000. There is no established market value for the...
-
Create a Visa credit card account for both Jon and Alice. Record the following credit cards transactions for Jon: a . Orfice Supplies at Ofrice Supplies Depot on the first of the month for $ 2 4 +...
-
Compute the missing amounts in the separate (partial) income statements A, B, and C. A B C Sales Sales discounts $ ? $20,000 $90,000 2,000 1,500 500 Sales returns and allowances 7,000 4,000 35,000 ?...
-
Presented below is the comparative balance sheet for Diatessaron Inc., a private company reporting under ASPE, at December 31, 2017 and 2016: Additional information: 1. Cash dividends of $15,000 were...
-
How can a scrum master help the team remain focused on achieving their iteration goals?
-
A project is 50% completed. An essential project team member requests two (2) months leave for personal matters. What should the project manager do first?
-
Explain various levels of involvement in the team situation. Analyze the team situation and identify reasons why the team did, and did not, perform effectively. Provide suggestions for improvement. ...
-
Describe two benefits of implementing self-awareness questionnaires in your workplace. Share two insights that you have gained as a result of this kind of assessment. What are the challenges in...
-
1. List and explain what benefits Mimitos will obtain with the creation of a website and online sales platform.
-
Water is leaking from the bottom of a conical cup that is 20 inches across and 20 inches deep. Given that the cup loses 0.5 cubic inches of water per minute, at what rate is the water level changing...
-
The rate at which the temperature of an object changes is proportional to the difference between its own temperature and the temperature of the surrounding medium. Express this rate as a function of...
-
What factors are involved in the shape of the curve shown in Fig. 16.6?
-
Why are there large differences between the specific energies involved in grinding and in machining? Explain.
-
What is a via? What is its function?
-
How does Philip Wallages view of the audit process compare the empirical scientific cycle to the financial audit process?
-
What are the five components of internal control? Give a sentence on each.
-
Name three influential international organizations in the field of accounting other than the IFAC?
Study smarter with the SolutionInn App