A cookie jar is moving up a 40o incline. At a point 55 cm from the bottom
Question:
(a) How much farther up the incline will the jar move?
(b) How fast will it be going when it has slid back to the bottom of the incline?
(c) Do the answers to (a) and (b) increase, decrease, or remain the same if we decrease the coefficient of kinetic friction (but do not change the given speed or location)?
Step by Step Answer:
This can be worked entirely by the methods of Chapters 26 but we will use energy methods in as many ...View the full answer
Fundamentals of Physics
ISBN: 978-0471758013
8th Extended edition
Authors: Jearl Walker, Halliday Resnick
Related Video
Static friction and kinetic friction are two types of friction that occur when two objects are in contact with each other. Static friction is the force that must be overcome to initiate motion between two surfaces that are in contact with each other but are not moving relative to each other. It is caused by the interlocking of rough surfaces at the microscopic level, and it increases as the force pushing the surfaces together increases. Once motion between the surfaces starts, the static friction is no longer present. Kinetic friction, also known as sliding friction, is the force that opposes the motion of two surfaces that are in contact with each other and are moving relative to each other. It is caused by the rubbing of the surfaces against each other and the resistance of the molecules in the surfaces to being moved. Kinetic friction is generally less than static friction, but it can still be a significant force, especially at high speeds. Both static and kinetic friction can be quantified using a coefficient of friction, which is a dimensionless number that represents the ratio of the frictional force between two surfaces to the normal force (the force perpendicular to the surfaces). The coefficient of static friction is typically greater than the coefficient of kinetic friction for a given pair of surfaces, because it takes more force to overcome the interlocking of the surfaces at rest than to maintain motion once it has started.
Students also viewed these Mechanics questions
-
If the coefficient of kinetic friction between a 35-kg crate and the floor is 0.30, what horizontal force is required to move the crate at a steady speed across the floor? What horizontal force is...
-
A bubble rises from the bottom of a lake of depth 80.0 m, where the temperature is 4 C. The water temperature at the surface is 18 C. If the bubble's initial diameter is 1.00 mm, what is its diameter...
-
If the coefficient of kinetic friction between a 22-kg crate and the floor is 0.30, what horizontal force is required to move the crate at a steady speed across the floor? What horizontal force is...
-
Argue whether or not you believe using a sample of students from your schools cafeteria (you recruit the next 100 people to visit the cafeteria to participate) may or may not yield biased estimates...
-
What is a bank's gap, and what does it attempt to determine? Interpret a negative gap. What are some limitations of measuring a bank's gap?
-
It is important for financial statements' external users to understand financial information about a company in which they have stakes. Financial information reported in the annual reports should not...
-
Animal-assisted therapy for heart patients. Refer to the American Heart Association Conference (Nov. 2005) study to gauge whether animal-assisted therapy can improve the physiological responses of...
-
Why are accountants so concerned about their organization having an efficient and effective internal control system?
-
Points
-
A financing statement that does not have the debtor's exact name should still be effective because creditors should always be protected when debtors default.
-
In Figure, a block of mass m = 2.5 kg slides head on into a spring of spring constant k = 320 N/m. When the block stops, it has compressed the spring by 7.5 cm. The coefficient of kinetic friction...
-
A stone with a weight of 5.29 N is launched vertically from ground level with an initial speed of 20.0 m/s, and the air drag on it is 0.265 N throughout the flight. What are? (a) The maximum height...
-
What are the relative values of the chemical shifts observed for nuclei in the spectrometers mentioned in Exercise 15.8a in terms of? (a) Values, (b) Frequencies?
-
Exhibit 12: Average Credit Quality Ratios [1] Based on this information you can compare O&Rs financial ratios to the average debt rating ratios above to assess what O&Rs credit rating would be if it...
-
Which of the following statements about QuickBooks Bill Pay are correct? Select all that apply. You can configure QuickBooks Bill Pay to pay bills automatically when they're added to QuickBooks...
-
Ash purchases 500 shares of XYZ for $10/share. Ten months later, when the shares are trading at $15/share, they donate them to Caring Trust, a qualified charity. Three months after the donation is...
-
Bob gets a X = 60 on his psychology exam and a X = 56 on his Biology exam. Psych exam scores had a =50 and =10 while Bio exam scores had a =48 and =4. Both professors grade on a curve. 1 - For which...
-
1. Lucky Company's direct labor information for the month of February is as follows: Actual direct labor hours worked (AQ) 61,500 Standard direct labor hours allowed (SQ) 63,000 Total payroll for...
-
What does it mean in your life and work context to put people first? How do you define diversity? How are you contributing to a diverse environment? What commitments do you need to make in order to...
-
Fred Farmer needs to prepare a balance sheet for his bank. He spent the day getting the following information. Fred needs your help to build a balance sheet and evaluate it. The information was...
-
Gun sights are adjusted to aim high to compensate for the effect of gravity, effectively making the gun accurate only for a specific range. (a) If a gun is sighted to hit targets that are at the same...
-
The relationship Lf = Li (1 + T) is an approximation that works when the average coefficient of expansion is small. If is large, one must integrate the relationship dL/dT =L to determine the final...
-
A steel wire and a copper wire, each of diameter 2.000 mm, are joined end to end. At 40.0C, each has an unscratched length of 2.000 m; they are connected between two fixed supports 4.000 m apart on a...
-
An aluminum calorimeter with a mass of 100 g contains 250 g of water. The calorimeter and water are in thermal equilibrium at 10.0C. Two metallic blocks are placed into the water. One is a 50.0-g...
-
Assume the market portfolio of common stocks earned 14.1 percent in one year while U.S. Treasury bills earned 4.4 percent and inflation averaged 4.6 percent. What was the market risk premium?
-
A bank quotes you an interest rate of 9 . 5 % per annum with quarterly compounding. What is the equivalent rate with continuous compounding?
-
Using automation tools leads to dislike 5 9 . How do the mechanical properties of woven fabric composites compare to those of unidirectional composites? Provide examples of applications for each type.
Study smarter with the SolutionInn App