By using the pre-emphasis filter shown in Figure a and with a voice signal as the modulating
Question:
By using the pre-emphasis filter shown in Figure a and with a voice signal as the modulating wave, and FM transmitter produces a signal that is essentially frequency modulated by the lower audio frequencies and phase-modulated by the higher audio frequencies. Explain the reasons for this phenomenon.
Fantastic news! We've Found the answer you've been seeking!
Step by Step Answer:
Answer rating: 85% (14 reviews)
Hf and Vinf Let Hf in the be out fn f or transfer ...View the full answer
Answered By
Ashish Jaiswal
I have completed B.Sc in mathematics and Master in Computer Science.
4.90+
20+ Reviews
39+ Question Solved
Related Book For
Question Posted:
Students also viewed these Telecommunication Engineering questions
-
The RC high-pass filter shown in Figure 33.25 has a resistance R = 0.500 . (a) What capacitance gives an output signal that has half the amplitude of a 300-Hz input signal? (b) What is the ratio (V...
-
The RC low-pass filter shown in Figure 33.26 has a resistance R = 90.0 and a capacitance C = 8.00 nF. Calculate the ratio (V out/V in) for an input frequency of (a) 600 Hz and (b) 600 kHz. You may...
-
Consider the IIR recursive filter shown in figure and let hF(n), hR(n), and h(n) denote the impulse responses of the FIR section, the recursive section, and the overall filter, respectively. (a) Find...
-
1. [20 points] A mattress manufacturer has three production facilities located in Pittsburg (PA), Houston (TX), and Los Angeles (CA). They supply their products to three distribution centers in...
-
A 14.0-kg bucket is lowered vertically by a rope in which there is 163 N of tension at a given instant. What is the acceleration of the bucket? Is it up or down?
-
A student is to swing a bucket of water in a vertical circle without spilling any (Fig. 7.32). (a) Explain how this task is possible. (b) If the distance from his shoulder to the center of mass of...
-
Presented below is a list of income statement and balance sheet accounts: a. Interest expense b. Land c. Cost of goods sold d. Intangible assets e. Income tax expense f. Inventory g. Revenues h....
-
Pan Corporation acquired a 75 percent interest in Saf Corporation on January 1, 2011. Financial statements of Pan and Saf Corporations for the year 2011 are as follows (in thousands): REQUIRED:...
-
Scenario: You are shipping 3 x 125 MT columns/oilfield equipment, each 70 ft long and 10 ft in diameter, from Wawa, Ontario to a refinery site near Brasilia, Brazil. Load port: Sault Ste. Marie,...
-
Managing Scope Changes Case Study Scope changes on a project can occur regardless of how well the project is planned or executed. Scope changes can be the result of something that was omitted during...
-
In the discussion on FM threshold effect presented in Section 2.13, we describe the condition for the positive-going and negative-going clicks in terms of the envelope r (t) and phase (t) of the...
-
In this experiment we study the behavior of the envelope detector shown in Figure for the following specifications: Source resistance, R s = 75. Load resistance, R l = 10. Capacitance, C = 0.01F. The...
-
Cashew Nut owns a bond that pays \($80\) in annual interest, with a \($1,000\) par value. It matures in 14 years. His required rate of return is 8 percent. a. Calculate the value of the bond. b. How...
-
What specific knowledge about computer controls should the auditor acquire in obtaining an understanding?
-
What are some of the differences between using computers and using a manual system on an entitys internal controls?
-
Describe the three main computer files used. What are their equivalents in a manual system?
-
. For each of the three methods of data processing, indicate (1) their essential characteristics and (2) an advantage and a disadvantage.
-
What are some factors that would make an auditor increase his or her assessment of the potential risk of irregularities for an audit client?
-
Explain the different techniques that firms can use to protect themselves from future changes in exchange rates.
-
Create a data model for one of the processes in the end-of-chapter Exercises for Chapter 4. Explain how you would balance the data model and process model.
-
Consider the balanced equation: Complete the table showing the appropriate number of moles of reactants and products. If the number of moles of a reactant is provided, fill in the required amount of...
-
Determine the power supplied to the elements shown A +2 . +8
-
A journal bearing has a shaft diameter of 75.00 mm with a unilateral tolerance of 0.02 mm. The bushing bore has a diameter of 75.10 mm with a unilateral tolerance of 0.06 mm. The bushing is 36 mm...
-
A full journal bearing is 25 mm long. The shaft journal has a diameter of 50 mm with a unilateral tolerance of 0.01 mm. The bushing bore has a diameter of 50.05 mm with a unilateral tolerance of 0.01...
-
T8.2 A confidence inteval fro a difference in proportions is -0.077 to 0.013. What are the point estimate and the margin of error for this interval
-
In view of mixed results by credit rating agencies in recent years (with both business and government entities), what measures do you think are important benchmarks in assessing credit worthiness?...
-
ABC1 is a recombinant DNA-derived Factor IX concentrate designed for individuals with hemophilia B, catering to the control and prevention of bleeding episodes on demand, perioperative management of...
Study smarter with the SolutionInn App