Question: If the roller at A and the pin at B can support a load up to 4 kN and 8 kN, respectively, determine the maximum

If the roller at A and the pin at B can support a load up to 4 kN and 8 kN, respectively, determine the maximum intensity of the distributed load w, measured in kN/m, so that failure of the supports does not occur.

30° 3 m 4 m

30 3 m 4 m

Step by Step Solution

★★★★★

3.34 Rating (166 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

Equations of Equilibrium N A can be determined directly by writing the m... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Engineering Mechanics Statics Questions!

(D)An oil pipeline and a 1.3-m3 rigid air tank are connected to each other by a manometer, as shown in the Figure below. If the tank contains 15 kg of air at 80C, determine: the absolute pressure in...

If neither the pin at A nor the roller at B can support a load no greater than Fmax determine the maximum intensity of the distributed load w, so that failure of a support does not occur. Units Used:...

If the roller at B can sustain a maximum load of 3 kN, determine the largest magnitude of each of the three forces F that can be supported by thetruss. 2 m -2 m 2 m

The smooth pin is supported by two leaves A and B and subjected to a compressive load of 0.4 kN/m caused by bar C. Determine the intensity of the distributed load w 0 of the leaves on the pin and...

If the roller at A and the pin at B can support a load up to 4 kN and 8 kN , respectively, then determine the maximum intensity of the distributed load w , measured in kN / m , so that failure of the...

Consider the beam shown in ( Figure 1 ) . The roller at \ ( A \ ) and the pin at \ ( B \ ) can support a load up to 3 . 7 kN and 8 . 5 kN , respectively. Figure Part A Determine the maximum intensity...

Consider the beam shown in ( Figure 1 ) . The roller at A and the pin at B can support a load up to 4 kN and 8 kN , respectively. Part A Determine the maximum intensity of the distributed load w ,...

Consider the beam shown in ( Figure 1 ) . The roller at \ ( A \ ) and the pin at \ ( B \ ) can support a load up to 3 . 7 kN and 9 . 2 kN , respectively. Part A Determine the maximum intensity of the...

Consider the beam shown in ( Figure 1 ) . The roller at \ ( A \ ) and the pin at \ ( B \ ) can support a load up to 3 . 7 kN and 9 . 8 kN , respectively. Determine the maximum intensity of the...

Problem 5 . 2 3 Consider the beam shown in ( Figure 1 ) . The roller at \ ( A \ ) and the pin at \ ( B \ ) can support a load up to 3 . 7 kN and 8 . 5 kN , respectively. Figure Part A Determine the...

Consider the beam shown in ( Figure 1 ) . The roller at \ ( A \ ) and the pin at \ ( B \ ) can support a load up to 3 . 8 kN and 9 . 5 kN , respectively. igure Part A Determine the maximum intensity...

An English teacher needs to pick 10 books to put on her reading list for the next school year, and she needs to plan the order in which they should be read. She has narrowed down her choices to 4...

Why dont coal, oil, and natural gas fit the accepted definition of a mineral? (See Problem 2.21)

17.18 Control limits for a dyeing process. The unique colors of the cashmere sweaters your firm makes result from heating undyed yarn in a kettle with a dye liquor. The pH (acidity) of the liquor is...

What is collateral estoppel? How does it affect tax research and planning?

The shelf supports the electric motor which has mass m 1 and mass center at Gm. The platform upon which it rests has mass m 2 and mass center at Gp. Assuming that a single bolt B holds the shelf up...

A cantilever beam, having an extended length L, is subjected to a vertical force F. Assuming that the wall resists this load with linearly varying distributed loads over the length a of the beam...

The upper portion of the crane boom consists of the jib AB, which is supported by the pin at A, the guy line BC, and the backstay CD, each cable being separately attached to the mast at C. If the...

On January 1, 2013, the Moody Company entered into a transaction for 100% of the outstanding common stock of Osorio Company. To acquire these shares, Moody issued $400 in long-term liabilities and 40...

help (Capital structure analysis) Last year the Rondoelea Products Company had $ 149 million in annual sales and a net profit margin of 9.3 percent. In addition, Rondoelea's average tax rate was 30...

Two words are anagrams of each other if one can be produced by a reordering of letters of the other. For example resistance and ancestries are a pair of anagrams. Another anagram pair is admirer and...