1) A system is loaded as shown in the figure below. Points A and C are bearing locations. Shaft is made of a steel having Sy: 567 MPa and Sut: 676 MPa. (All dimensions are in mm, D/d is 1.1 and fillet radius are 3 mm.) a) Evaluate the total forces, moments and torques acting onto the system. b) Design the shaft based on a factor of safety of A,B for 90 percent reliability and infinite life. The shaft is machined surface. Z A 2AB 0120 B 2AB 350N 1AB 600N 400N E 250N 0160 NOTE! State all the assumptions that you make in design process in the assignment.