Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

1. From your results in Tables 2, 3 and 4- of your lab procedure: a. Plot the power across the 1 K0. resistor for the

image text in transcribedimage text in transcribed
image text in transcribedimage text in transcribed
1. From your results in Tables 2, 3 and 4- of your lab procedure: a. Plot the power across the 1 K0. resistor for the three solar cells as a function of illumination level for shadow, at and direct sunlight b. Plot the power per square cm of solar cell area across the 1 K9. [or 1009] resistor for the three solar cells as a function of illumination level for shadow, at and direct sunlight c. Plot the power per solar cell dollar across the 1 K11 [or 10011] resistor for the three solar cells as a function of illumination level for shadow, at and direct sunlight Table 2 - Flat Amorphous CIS Monocrystalline Voltage without load 3. 938 V 4. 187 v 6.45 V Current without load 3. 98 MA 34. 02 m A 9. 29 mA Voltage across 1kQ 1 3. 065 V 3. 961 V 5. 89 V 4. Leaving the EB where it is, have one partner use a hand and cover each solar cell in a shadow while you make your measurement. Now, only diffuse sunlight enters the solar cells. Repeat the measurements taken in Step #1 in this new lighting configuration. Record your measurements in Table 3. Table 3 - Shadow Amorphous CIS Monocrystalline Voltage without load 3. 854 V 3. 187 V 4.98 V Current without load 3. 10 m A 3.0 m A 0. 82 MA Voltage across 1kQ 2, 56 V 2. 182 V 1.046 V 5. Have one partner tilt the EB so that the solar cells are facing directly towards the sun, with no shadows falling on it. Repeat the measurements taken in Step #1 in this new lighting configuration. Record your measurements in Table 4. Table 4 - Direct Sunlight Amorphous CIS Monocrystalline Voltage without load 3. 779 V 4. 366 V 6. 77 V Current without load 2. 45 MA 72. 1 MA 21. 4 m A Voltage across 1kQ 2. 3 4 V 4. 21 V 6.53 V 6. Get data from the pre-calibrated CIS solar cell on EB#1 from your TA. You will use the current without load measurements in the calibrated cells to later determine the incident solar radiation on the roof during your lab section. Record these values in Table 5. Table 5 - Calibrated Cell Measurements Calibrated CIS Current without load 78 MA

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Essential University Physics

Authors: Richard Wolfsonby

3rd Edition Volume 2

321976428, 978-0321976420

More Books

Students also viewed these Physics questions

Question

Is American Express liable to Gray for violating the FCBA?

Answered: 1 week ago

Question

1. What will happen in the future

Answered: 1 week ago

Question

3. Avoid making mistakes when reaching our goals

Answered: 1 week ago