1.) Open the simulation by clicking on the following link: Charges and Fields 1.0.60 (colorado.edu) 2.) You will see two charges at the bottom of the screen (+1nC and -1nC) and an electric field sensor ("sensor"). You can drag charges to the workspace by clicking and dragging. Create a parallel-plate capacitor by vertically lining up a collection of closely space positive charges on the left, and negative charges on the right as shown in the image below. +1 ne Charges and Fields PHET Charges 3.) In the space between the two plates of the parallel-plate capacitor, does the field go from the positive plate to the negative plate or from the negative plate to the positive plate? 4.) There is a voltmeter on the right-hand side of the screen. This device will be used to measure the voltage (potential) at various points between the two plates of the parallel-plate capacitor. Drag the voltmeter to the workspace. Leche Fisk 0 Voltmeter Charges and Fields PHET=