1. Setup the following topology Server-P DHCP 2960-24TT PC-PT PCO FC-PT PC3 Classroom Switch1 PC-PT PC1 2960-24TT Station Switch0 PC-PT PC2 1841 Router0 2960-24TT Switch2 Server-PT DNS 2. Configure the DHCP server with the following IP address information IP address: 172.17.13.253 Subnet Mask: 255.255.255.0 (NOTE: THIS IS NOT THE DEFAULT) Default Gateway: 172.17.13.1 3. Configure the DHCP server with the following DHCP pool information Default Gateway: 172.17.13.1 DNS Server: 172.17.11.16 Start IP Address: 172.17.13.10 Subnet mask: 255.255.255.0 (NOTE: THIS MAY NOT BE THE DEFAULT) Max Number of Users: 30 4. Configure the DNS server with the following IP address information IP address: 172.17.11.16 Subnet Mask: 255.255.255.0 (NOTE: THIS IS NOT THE DEFAULT) Default Gateway: 172.17.11.1 5. Configure the PCs to obtain an address automatically from the DHCP server 6. Configure the router with the following IP information FastEthernet0/0: IP Address: 172.17.13.1 Subnet Mask: 255.255.255.0 (NOTE: THIS IS NOT THE DEFAULT) FastEthernet0/1: IP Address: 172.17.11.1 Subnet Mask: 255.255.255.0 Click on the Settings button on the Config tab. Click the Save button next to the NVRAM button to save your configuration on the Cisco Router. Failure to do this will cause your configuration to be lost when the router restarts 7. If everything has been configured correctly, you should be able to ping the DNS" server from any of your PCs. Submit a copy of the topology and the successful ping for 100 points. Submit a copy of the topology only (no successful ping) for 50 points.