1. Well ULL-B has been drilled to a Total Depth of 6000ft. Casing for this well was run as follows: Surface casing: 13/3/8 to 2000ft Intermediate casing 9-5/8" to 5300ft Production hole 8-1/2" to 6000ft The formation is consolidated sandstone and no sand problems are expected. a. Name two (2) completion methods that you would propose for this well b. State one (1) advantage and one (1) disadvantage of each of these completion methods c. Construct a detalled wellbore sketch of the proposed completion you have selected. 2. A newly drilled well encountered the following major productive zones: Deeper middle Cruse sands from 6,000ft to 6,400ft Shallower upper Cruse sands from 3,900 ft to 5,200ft The Government has indicated that it would grant permission to produce both zones separately, that is with no comingling of the zones. a. Compose a wellbore sketch of a completions configurations which will allow production from both zones simultaneously through different strings of pipe b. Compose a wellbore sketch of a completions configuration which will allow production from one zone after the other without having to resort to a recompletion workover. Key word: sliding sleeve, circulation sleeve