Answered step by step
Verified Expert Solution
Question
1 Approved Answer
16. Which component view of a technical drawing shows a cross-section of the source object along the specified cut plane? a. Multi-view projection b. Auxiliary
16. Which component view of a technical drawing shows a cross-section of the source object along the specified cut plane? a. Multi-view projection b. Auxiliary projection c. Sectional view d. Detail projection 17. A secondary measurement standard is best defined as the standard: a. Whose value is derived by comparison to a national or primary standard b. Used on a shop floor c. Used routinely to calibrate or check material measures d. Whose value is derived by comparison to the contractors' internal standard 18. Which QA-related provision in the FAR/DFARS ensures that Government quality assurance is included in procurement contracts? a. Higher-Level Quality Standards b. Acceptance c. Contract Quality Requirements d. Government Contract Quality Assurance 19. The ability to relate the result of a measurement to a national and/or international measurement standard through an unbroken chain of documented comparisons is called what? a. Traceability b. Metrology c. Calibration d. Orientation 20. What process can a supplier use to prevent counterfeit parts from being presented for Government acceptance? a. Researching fair market price b. Maintaining a quality management system c. Implementing Six Sigma d. Using Level 3 vendors 21. What information should be included in a process map? a. Only the
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access with AI-Powered Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started