192.168.1.0/25 192.168.1.128/25 Fa0/0 Fa0/1 Fao Fao R1 PC2 PCO Fab/ Fa0/24 Fa0/2 Fa0/1 Fa0/2 SW1 SW2 Fa0/2 Fao Fao Configuration Laptop PC1 PC3 Notes: Configuration questions are only limited to RI, SW1, SW2, PCO, PCI, PC2 and PC3. Commands Parameters are key sensitive. You must use the configuration laptop to configure the devices using console cable On R1 1. Change the hostname to be ROUTERA 2. Set the IP address on FastEthernet 0/0 to be the last usable IP Address of 192.168.1.0/25 and turn it on. 3. Set the IP address on FastEthernet 0/1 to be the last usable IP Address of 192.168.1.128/25 and turn it on. 4. Set a banner (motd) to be ACCESS IS DENIED 5. Secure the Console Port with a password NOENTER 6. Set enable password to be ENPASS 7. Enable Service Password Encryption 8. Save your configuration On SW1 1. Change the hostname to be SW-1 2. Set SVI IP on VLAN 1 to be 192.168.1.100 with the right subnet mask and turn it on. 3. Set the gateway address with the last usable IP address of 192.168.1.0/25 4. Save your configuration On SW2 1. Change the hostname to be SW-2 2. Set SVI IP on VLAN 1 to be 192.168.1.200 with the right subnet mask and turn it on. 3. Set the gateway address with the last usable IP address of 192.168.1.128/25 4. Save your configuration On PCO 1. Set the First usable IP Address 2. Set the proper subnet mask 3. Set the proper gateway address On PC1 1. Set the Second usable IP Address 2. Set the proper subnet mask 3. Set the proper gateway address On PC2 4. Set the First usable IP Address 5. Set the proper subnet mask 6. Set the proper gateway address On PC3 1. Set the Second usable IP Address 2. Set the proper subnet mask 3. Set the proper gateway address