Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

5. Figure 5.28 shows a small three-part assembly that is to be assembled automati- cally. Carry out an analysis of this assembly for high-speed

  

5. Figure 5.28 shows a small three-part assembly that is to be assembled automati- cally. Carry out an analysis of this assembly for high-speed automatic assembly and from this determine the estimated assembly cost. The assemblies are required at a rate of 10 per minute. The cost of using a standard feeder for 1 s is 0.03 cents and the cost of using a standard workhead for 1 s is 0.06 cents. The screw has a pilot point and so is easy to align and position into the screw hole. FIGURE 5.28 Three-part assembly. 5 mm 5 mm Plastic base Screw 12 mm Metal clip 20 mm

Step by Step Solution

3.44 Rating (154 Votes )

There are 3 Steps involved in it

Step: 1

Solution Given that The assemblies are required at a rate of 10 per minute The ... blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Statistics For Psychology

Authors: Arthur Aron, Elaine N. Aron, Elliot J. Coups

6th Edition

205258158, 978-0205258154

More Books

Students also viewed these General Management questions