6. When using conventional Which one of the fol coatvolume-profit analysis, some assumptions about cos and sales prices are g is one of those assumptions? A. The contribution margin will change as volume increases B. The variable cost per unit will decrease as volume increases C. The sales D. Fixed costs per unit will remain the same as volume increases E. The actual variable cost per unit must vary over the production range price per unit will remain constant as volume increases 7. Under variable costing, which costs are included in product cost? A. variable product costs, including direct materials, direct labor, and variable overhead B. All variable and fixed allocations of product costs, including direct materials, direct labor, and both variable and fixed overhead C. All variable product costs except for variable overhead D. All variable and fixed allocations of product costs, except for both variable and fixed overhead. S. A company's forecasted sales are $300,000 and its sales at break-even are $180,000. Its margin of safety in dollars is A. $180,000, B. $120,000 C. $480.000 D. $60,000 E. $300,000 9. A company is currently operating at 0% capacity producing and 5,000 units. Current cost information relating to this production is shown in the table below Per Unit S34 Sales price Direct matcrial S2 Direct labor Variable overhead 4 $5 Fised overhead The company has been approuched by a customer with a request for a 100 unit special order. What is the minimum per unit sales price that management would accept for this order if the company wishes to increase current protis? A. Any amount over $34 per unit. B. Any amount over $20 per unit. C. Any amount over SI-4 per unit. D. Any amount over $9 per unit. E. Any amount over $5 per unit. 10. A method of assigning overhead costs to a product using a single overhead rate is: A. Plantwide overhead rate method. B. Cost pool overhead rate method D. Activity-based costing E. Overhead cost allocation method