Answered step by step
Verified Expert Solution
Question
1 Approved Answer
A 17-tooth 20 pressure angle spur pinion rotates at 1800 rev/min and transmits 4 hp to a 52- tooth disk gear. The diametral pitch
A 17-tooth 20 pressure angle spur pinion rotates at 1800 rev/min and transmits 4 hp to a 52- tooth disk gear. The diametral pitch is 10 teeth/in, the face width 1.5in, and the quality standard in No. 6. The gears are straddle-mounted with bearings immediately adjacent. The pinion is a grade 1 steel with a hardness of 240 Brinell tooth surface and through-hardened core. The gear is steel, through-hardened also, grade 1 material, with a Brinell hardness of 200, tooth surface and core. Poisson's ratio is 0.30, Jp=0.30, Jg=0.40, and Young's modulus is 30(106) psi. The loading is smooth because of motor and load. Assume a pinion life of 108 cycles and a reliability of 0.90, and use YN=1.3558N-0.0178, ZN=1.4488N-0.023. The tooth profile is uncrowned. This is a commercial enclosed gear unit. a) Find dp, V and Wt b) Find Ky assuming Ko=1 a. Find the Lewis form factor K, for the gear and pinion c) Find KM and YN for the pinion and gear, KB=1 d) For K=1 and C=1, find I and Cp e) Find the endurance strength, the stress, and safety factor in bending for the pinion and the gears f) Find the surface strength, stress, and safety factor for wear for the pinion and the gear A 17-tooth 20 pressure angle spur pinion rotates at 1800 rev/min and transmits 4 hp to a 52- tooth disk gear. The diametral pitch is 10 teeth/in, the face width 1.5in, and the quality standard in No. 6. The gears are straddle-mounted with bearings immediately adjacent. The pinion is a grade 1 steel with a hardness of 240 Brinell tooth surface and through-hardened core. The gear is steel, through-hardened also, grade 1 material, with a Brinell hardness of 200, tooth surface and core. Poisson's ratio is 0.30, Jp=0.30, Jg=0.40, and Young's modulus is 30(106) psi. The loading is smooth because of motor and load. Assume a pinion life of 108 cycles and a reliability of 0.90, and use YN=1.3558N-0.0178, ZN=1.4488N-0.023. The tooth profile is uncrowned. This is a commercial enclosed gear unit. a) Find dp, V and Wt b) Find Ky assuming Ko=1 a. Find the Lewis form factor K, for the gear and pinion c) Find KM and YN for the pinion and gear, KB=1 d) For K=1 and C=1, find I and Cp e) Find the endurance strength, the stress, and safety factor in bending for the pinion and the gears f) Find the surface strength, stress, and safety factor for wear for the pinion and the gear
Step by Step Solution
★★★★★
3.36 Rating (146 Votes )
There are 3 Steps involved in it
Step: 1
To solve this problem well go through each part step by step Lets start with part a a Find dp V and ...Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started