A 500 g steel block rotates on a steel table while attached to a 2.0-m -long massless rod. Compressed air fed through the rod is ejected from a nozzle on the back of the block, exerting a thrust force of 3.5 N . The nozzle is 70? from the radial line, as shown in (Figure 1). Figure1 of 1 A 2.0 meter long straight rod is pivoted at its end. A block is attached to another end of the rod. The rod and block rotate counterclockwise about the pivoted end. The block has a nozzle on its back side, the air is ejected from this nozzle. The block is tilted so that the air flows at an angle of 70 degrees with the extension of the rod.

Part A What is the block's angular velocity after 10 rev? Express your answer with the appropriate units.

Part b What is the tension in the rod after 10 rev?

As the calculations are correct . If the answer of part I is demanded in 7pm, Then 20.33 rad/ 194. 1372 7PM Other than this , There is no problem. or may be please check the question again from which it is typed and mention in the comments