FREE Trial
Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

A jet of water 80 mm diameter and has a velocity of 20 m/sec striking at the center of the hemispherical vane. The liner velocity

A jet of water 80 mm diameter and has a velocity of 20 m/sec striking at the center of the hemispherical vane. The liner velocity of the vane is 10 m/sec. in the direction of jet. Find the force exerted on the vane in the direction of jet also calculate the work done.

Step by Step Solution

★★★★★

3.42 Rating (152 Votes )

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Fundamentals Of Hydraulic Engineering Systems

Fundamentals Of Hydraulic Engineering Systems

Authors: Robert J. Houghtalen, A. Osman H. Akan, Ned H. C. Hwang

4th Edition

136016383, 978-0136016380

More Books

Students also viewed these Mechanical Engineering questions

Question

★★★★★
A jet of water 75 mm diameter at its base rises vertically to a height of 18 m. Obtain an equation for the diameter of the jet at any height above the base assuming that the jet does not break up and...

Answered: 1 week ago

Question

★★★★★
A jet of water having a cross-sectional area of 4 in2 strikes the fixed blade with a speed of 25 ft/s. Determine the horizontal and vertical components of force which the blade exerts on the water....

Answered: 1 week ago

Question

★★★★★
Find the force exerted on the strut by the hinge at A for the arrangement in Figure if (a) The strut is weightless, and (b) The strut weighs 20N. 45 60 N

Answered: 1 week ago

Question

★★★★★
Write the boldfaced numbers in each problem in scientific notation. The largest of the 50 United States is Alaska, with land area of about 365,482,000 acres, while the smallest is Rhode Island, with...

Answered: 1 week ago

Question

★★★★★
In the circuit of Fig. 19.65, the input port is connected to a 1-A dc current source. Calculate the power dissipated by the 2 - resistor by using the y parameters. Confirm your result by direct...

Answered: 1 week ago

Question

★★★★★
The cable AO exerts a force on the top of the pole of F = {?120i ? 90j ? 80k} lb. If the cable has a length of 34 ft, determine the height z of the pole and the location (x, y) of its base.

Answered: 1 week ago

Question

★★★★★
Formal agreements: What evidence is there that the evaluation was based on negotiated and renegotiated formal agreements, taking into account the contexts, needs, and expectations of clients and...

Answered: 1 week ago

Question

★★★★★
A study of Kickstarter projects showed that 54.2% were successful, that is, achieved its goal and raised at least the targeted goal amount. In an effort to identify network dynamics that influences...

Answered: 1 week ago

Question

★★★★★
Green Manufacturing, Inc., plans to announce that it will issue $1.93 million of perpetual debt and use the proceeds to repurchase common stock. The bonds will sell at par with a coupon rate of 5...

Answered: 1 week ago

Question

★★★★★
You are working on a free-form Packet Tracer challenge activity as seen in Figure 1, you have been given the London Railways network.' The purpose of this EMA question is to build upon each of the...

Answered: 1 week ago

Question

★★★★★
Down Under Products, Ltd., of Australia has budgeted sales of its popular boomerang for the next four months as follows: April May June July Unit Sales 90,000 95,000 130,000 100,000 The company is...

Answered: 1 week ago

Question

★★★★★
Create a circuit that has 7 input bits IN0 to IN6, that drive one seven segment display in the order indicated below. Find out to which values the 7 input bits need to be set to get the decimal...

Answered: 1 week ago

Question

★★★★★
You know the following concerning a common stock: EPS$3.00 Payout ratio25% P/E10 Annual ROR6% of earnings and div 1) If you want to earn 10% percent, should you buy this stock? 2) What is the maximum...

Answered: 1 week ago

Question

★★★★★
What is the speedup of the basic pipeline (with branch predictions) shown in the Introduc- tion slides (Tsequential / Tpipelined) if 1/5 of all instructions are conditional branches and 4/5 of them...

Answered: 1 week ago

Question

★★★★★
3.You borrow $10,000 from Friendly Finance for four years with quarterly payments keyed to a 10% interest rate.$1,000 interest each year plus $10,000 equals $14,000.Spread over 4 years this loan...

Answered: 1 week ago

Question

★★★★★
reword Chaukhats should be seasoned teak wood. Shutters should be teaked wood 4.3cm thick penelled and partly glazed as required with additional wire gauge shutters. Allfitting should be brass. Doors...

Answered: 1 week ago

Question

★★★★★
Which of the following disclosures are required to be delivered to a client in writing when a CFP professional provides financial planning advice? How the client pays Material conflicts of interest...

Answered: 1 week ago

Question

★★★★★
What is a lobbyist in US? How did this term emerge?

Answered: 1 week ago

Question

★★★★★
Complete Example 6.10. In that example problem, water depths were required in the discharge channel until the water level was within 2 percent of normal depth. Depths were found at 2 ft and 7 ft...

Answered: 1 week ago

Question

★★★★★
The elevation difference between two reservoirs 2,000 m apart is 20 m. Compute the flow rate if (a) A 30-cm commercial steel (CHw = 140) pipeline connects the reservoirs and (b) Two 20-cm commercial...

Answered: 1 week ago

Question

★★★★★
In Chapter 8, it was stated that an essential feature of weirs is that flow achieves critical depth passing over the weir. Because that is the case, derive Equation 9.9 using Equation 6.14, which...

Answered: 1 week ago

Question

★★★★★
Determine the margin of error for a confidence interval estimate for the population mean of a normal distribution given the following information: a. confidence level 0.98, n 13, s 15.68 b....

Answered: 1 week ago

Question

★★★★★
Assuming the population of interest is approximately normally distributed, construct a 95% confidence interval estimate for the population mean given the following values: s 4.2 n 13

Answered: 1 week ago

Question

★★★★★
Construct a 95% confidence interval estimate for the population mean given the following values: s 55 n 250

Answered: 1 week ago

Previous Question Next Question