Question
A piston requires a valve diameter of 25mm 0.7mm in the specification document. The Tondex Fabricator Company has a process that produces pistons with mean
A piston requires a valve diameter of 25mm
0.7mm in the specification document. The Tondex Fabricator Company has a process that produces pistons with mean valve diameters of 25mm and a standard deviation of 0.25mm, normally distributed. Currently Tondex maintains a quality control level that accepts middle 95% of the fabricated pistons over the normally distributed process parameter.
Find the proportion of the manufactured pistonsthat will pass specification requirements but not quality control.
Round off your answer to 2 decimal places. Put a zero '0' before the decimal point in your answer if needed.
The equivalent standard normal value at the lower specification limit is:
For the next 2 question enter your answer as "(valve diameter value) to (valve diameter value)". Example: 25.50 to 27.50.
The 1st range (lower range) of valve diameter values that represents passing specification requirement but not quality control is :
The 2nd range (higher range) of valve diameter values that represents passing specification requirement but not quality control is:
The proportion of the manufactured pistonsthat will pass specification requirements but not quality control :
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started