Question: A rectangular resistor (shown below) is made of some material with resistivity 0-001 2 m. The end face of the resistor is of rectangular

A rectangular resistor (shown below) is made of some material with resistivity

A rectangular resistor (shown below) is made of some material with resistivity 0-001 2 m. The end face of the resistor is of rectangular cross section, with the width being 1.0cm (as shown) and the height being 2.0 cm. The length of the resistor is 120 cm. When this resistor is connected across a battery with internal resistance 0.4 ohms the voltmeter connected to the terminals of the battery reads 12 volts. What is the emf of this battery? Select the closest answer: O 14 O 12.8 V O 11.2 V O 12 V O 13.4 V

Step by Step Solution

★★★★★

3.41 Rating (148 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock

from figure of resistox Area of cronn seetion reetangule... View full answer

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Physics Questions!

The component shown below is made of AISI 4340 Oil Quenched at 800C and Temper at 5950C 1hour (oyield=139ksi; OTs=147ksi) tubular steel. The component, a closed end tube with an OD=1.25in and...

The truss shown below is made?from three pin-connected members having the?cross-sectional areas shown in the figure. Calculate the average normal stress developed ieach member when the truss is...

A voltmeter connected across a resistor always reads less than the actual voltage across the resistor when the meter is not present. Explain.

A cast-steel C frame as shown in the figure has a rectangular cross section of 1 in by 1.6 in, with a 0.4-in-radius semicircular notch on both sides that forms midflank fluting as shown. Estimate A,...

A beam of rectangular cross section (width b and height h) supports a uniformly distributed load along its entire length L. The allowable stresses in bending and shear are allow and allows,...

In the middle of a long solenoid there is a coaxial ring of square cross-section, made of conducting material with resistivity p. The thickness of the ring is equal to h, its inside and outside radii...

A wood beam of rectangular cross section (see figure) is simply supported on a span of length L. The longitudinal axis of the beam is horizontal, and the cross section is tilted at an angle a. The...

Four circuit elementsa capacitor, an inductor, a resistor, and an AC sourceare connected together in various ways. First the capacitor is connected to the source, and the rms current is found to be...

A coaxial resistor of length l consists of two concentric cylinders. The inner cylinder has radius a and is made of a material with conductivity 1, and the outer cylinder, extending between r...

A 25.0- bulb is connected across the terminals of a 12.0-V battery having 3.50 of internal resistance. What percentage of the power of the battery is dissipated across the internal resistance and...

Smith Ltd. was in the process of preparing year-end adjusting entries for the year ended December 31, 2018. Smith Ltd. had the following balance in their books (ledger): Dr. Cr. Accounts Receivable...

Financial statements all have a goal. The statement of cash flows does as well. Describe how the statement of cash flows helps investors and creditors perform each of the following functions a....

What IRC provision best describes the deduction of organizational expenditures for a corporation?

Tanger Company purchased a delivery truck for R$38,000 on January 1, 2017. The truck has an expected residual value of R$6,000, and is expected to be driven 100,000 miles over its estimated useful...

Discuss the octane number and cetane number.

A solution is prepared at 20C and its concentration is expressed in two different units; Molarity and Molality. The solution is then heated to 88C. Which of the concentration units will change?

Directions: Using the curve below describe what is happening between each of the points: C B D F Time (min) i. A-B ii. B-C iii. C-D iv. D-E V. E-F Temperature (C)

Let S = {vi, v2, 03} where o = (1,0, 1), = (1,1,0) and (0,0, 1) be a basis of R3. Let T = {w1, w2, ws} be another basis of R. Suppose that the %3D %3D %3D %3D transition matrix from T to S is 17 PsT...

The overall, three-dimensional, structure of the protein is called what? Question 36 options: Primary structure Secondary structure Tertiary structure Quaternary structure

X ~ Messenger Classes Read chapter 12 - Current & Resi X *Homework Help - Q&A from Onl X + X C A https://classroom.google.com/u/2/c/NDQ3NZYwNDEwOTkw/a/NDg1NTYSNTY5MDMO/details POF chapter 12.pdfneers...

Summarize this for me. Someone who understand the HEA and MEA perfectly and also the summary should be 2 or over 2 pages. Someone who understands this perfectly A scrap-tolerant alloying concept...

I'm having difficulty solving these problems 1)A solenoid 3.37 cm in diameter and 25.9 cm long has 223 turns and carries a current of 8 A. Find the magnetic flux through the circular cross-sectional...

in Fig. The diameters 1. An som An som long steel made of middle and the last segments of the bar are 30 mm, 25 mm and 30 mm respectively. Also, find the elongation of the bar. E = 200 GPa 200 kN P...

Review 2C PHYS 22100 Name Use the sketch shown below to answer the next 3 questions. The sketch shows a region of space with regions of uniform electric potential indicated by dashed lines. Eight...

This text was adapted by The Saylor Foundation under a Creative Commons Attribution-NonCommercial-ShareAlike 3.0 License without attribution as requested by the work's original creator or licensee....