Altex Inc. manufactures two products: car wheels and truck wheels. To determine the amount of overhead to assign to each product line, the controller, Robert Hermann, has developed the following information. Car Truck 36,000 11,000 Estimated wheels produced Direct labor hours per wheel 1 3 Total estimated overhead costs for the two product lines are $800,400. Calculate overhead rate. (Round answer to 2 decimal places, e.g. 12.25.) Overhead rate per direct labor hour Compute the overhead cost assigned to the car wheels and truck wheels, assuming that direct labor hours is used to allocate overhead costs. Car wheels $ Truck wheels $ Hermann is not satisfied with the traditional method of allocating overhead because he believes that most of the overhead costs relate to the truck wheels product line because of its complexity. He therefore develops the following three activity cost pools and related cost drivers to better understand these costs. Estimated Use of Cost Drivers Activity Cost Pools Setting up machines Assembling Inspection 1,000 setups 69,000 Tabor hours 1,200 inspections Estimated Overhead Costs $207,000 345,000 248,400 Compute the activity-based overhead rates for these three cost pools. Overhead Rates Setting up machines $ 207 Assembling $ Inspection $ 207 Compute the cost that is assigned to the car wheels and truck wheels product lines using an activity-based costing system, given the following information. Estimated Use of Cost Drivers per Product Car Truck 200 800 Number of setups Direct labor hours Number of inspections 36,000 33,000 1,100 100 Car Wheels Truck Wheels Setting up machines $ ta $ Assembling $ Inspection ta Total cost assigned $