Assignment Instructions Unit 4 Case 2: Sooner Health Network SOONER HEALTH NETWORK (the Network), which consists of five medical group practices, is a subsidiary of not-for-profit Sooner Health System (the System). The Network includes both primary care and specialty physicians, with an emphasis on obstetrics/gynecology, eldercare, and pediatrics. Prior to the founding of the Network, the five practices operated independently. The Network has three practice locations, each staffed with a mix of primary care and specialist physicians. Although the Network itself is only marginally profitable, it is an important contributor to the profitability of the System because it generates a large amount of revenues from referrals for both inpatient admissions and inpatient and outpatient ancillary services. In fact, each $1 of revenue generated within the Network is estimated to lead to $8 of inpatient and ancillary revenues to the System. By limiting the amount of ancillary services provided at the three Network locations, patients are forced (or at least encouraged) to use other System facilities for such services. Still, some ancillary services are best performed at the Network locations for one or more of the following reasons: lower costs, increased physician efficiency, and improved patient convenience and hence better CAHPS (Consumer Assessment of Healthcare Providers and Systems) scores. For example, one of the practice locations now has a diagnostic imaging capability. When the scanner was moved from another facility to the Network location, volume increased, costs decreased, and both physician and patient satisfaction improved. (For more information on the CAHPS program, see www. ahrq.gov/ cahps/ about-cahps/index.html) The proposal currently being considered by the Network is to provide ultrasound services at the Network locations. Preliminary analysis indicates that two approaches are most suitable. Alternative 1 involves the purchase of one ultrasound machine for each of the Network's three locations. Patients would schedule appointments, generally at the clinic they are using, during preset times on specified days of the week. Then, the full-time ultrasound technician would travel from one location to another to administer the tests as scheduled. Alternative 2, on the other hand, involves the purchase of only one ultrasound machine, but patient scheduling would be the same. The machine would be mounted in a van that the technician would drive to each of the three Network locations. Most of the operating costs of the two alternatives are identical, but Alternative 2 has the added cost of operating the van and setting up the machine after each move. The two alternatives differ substantially in capital investment costs because Alternative 1 requires three ultrasound machines, at a cost of $100,000 each, whereas Alternative 2 requires only one machine. However, Alternative 2 requires a van, which with necessary modifications would cost $40,000. Thus, the capital costs for Alternative 1 total 3 x $100,000 = $300,000, whereas the costs for Alternative 2 amount to only $100,000 + $40,000 = $140,000. Because the two alternatives have different operating costs, a proper cost analysis of the two alternatives must include both capital investment and operating costs. The Network financial staff, which is the System financial staff, considered several methods for estimating the operating costs of each alternative. After much discussion, the chief financial officer (CFO) decided that the activity-based costing (ABC) method would be best. Furthermore, an ad hoc task force was assigned to perform the cost analysis. To begin the ABC analysis, the task force had to develop the activities involved in the two alternatives. This task was accomplished by conducting walkthroughs of the entire process from the standpoint of the patient, the ultrasound technician, and the billing and collections department. The results are shown in exhibit 4.1. A review of the activities confirms that all except one - consisting of transportation, setup, and breakdown - are applicable to both alternatives. The next step in the ABC process is to detail the costs associated with each activity. This step uses financial, operational, and volume data, along with the appropriate cost driver for each activity, to estimate resource consumption. Note that traditional costing, which often focuses on department-level costs, typically first deals with direct costs then allocates indirect (overhead) costs proportionally according to a predetermined allocation rate. In ABC costing, the activities required to produce some service, including both direct and indirect, are estimated simultaneously. For example, exhibit 4.1 contains activities that entail direct costs (such as technician time) and activities that entail indirect costs (such as billing and collection). Although the ABC method is more complex and hence costlier than the traditional method, it is the only way to accurately (more or less) estimate the costs of individual services. Activity cost detail on a per procedure basis is contained in exhibit 4.2. Each activity is assigned a cost driver that is most highly correlated with the actual utilization of resources. Then, the number of driver units, along with the cost per unit, is estimated for each activity. The product of the number of units and the cost per unit gives the cost of each activity. Finally, the activity costs are summed to obtain the total per procedure cost. Many of the activity costs cannot be calculated without an estimate of the number of ultrasounds that will be performed. The best estimate is that 50 procedures would be done each week, regardless of which alternative is chosen. Assuming the technician works 48 weeks per year, the annual volume estimate is 2,400 procedures. Of course, one factor that complicates the analysis is that a much greater total volume can be accommodated under Alternative 1 (with three machines) than with Alternative 2 (with only one machine). However, to keep the initial analysis manageable, the decision was made to assume the same annual volume regardless of the alternative chosen. Other costs are thought to be relevant to the decision. First, in addition to the purchasing and operating (primarily consisting of fuel expenses) costs of the van, the estimated annual vehicle maintenance costs are $1,000. Furthermore, annual maintenance costs on each of the three ultrasound machines under Alternative 1 are estimated at $1,000, whereas the annual maintenance costs for the single machine under Alternative 2 are estimated higher, at $1,500, because of added wear and tear. The manufacturer of the ultrasound machines has indicated that a discount may be available if three machines, as opposed to only one, are purchased. The amount of the discount is somewhat uncertain, although 5 percent has been mentioned. Finally, to get a rough estimate of the total annual costs over the life of the equipment, assumptions about the useful life of the ultrasound machines and the van must be made. Although somewhat controversial, the decision was made to assume a five-year life for both the ultrasound machines and the van and that the value of these assets would be negligible at the end of five years. Instructions You are the chair of the Network's ad hoc task force. Your charge is to evaluate the two alternatives and to make a recommendation on which one to accept, if revenues would be identical for the two alternatives, and hence the decision can be made solely on the basis of costs. As part of the analysis, the costs of the two alternatives must be estimated on a per procedure basis and an annual basis. In addition, any relevant qualitative factors must be considered before the recommendation is made. To keep the base case analysis manageable, the task force was instructed to assume that the operating costs remain constant over the useful life of the equipment. For comparative purposes, this assumption is not too egregious because the activities are roughly the same for both alternatives and, hence, inflation would have a somewhat neutral impact on the cost comparison. In addition, the System CFO has asked the task force to perform some sensitivity (scenario) analyses. He is concerned about the accuracy of the cost detail inputs. Although he is confident about many of the estimates, he thinks others are more arbitrary. Those activity cost inputs considered to be most uncertain are supplies cost per unit; billing and collection cost per unit; general administration cost per unit; and transportation, setup, and breakdown cost per unit. Thus, first, the task force must redo the analysis assuming that these inputs are higher than the base case values by 10 and 20 percent. Activity cost inputs less than the base case values could also be examined, but the critical issue here is not to underestimate the total costs involved in the two alternatives. Second, the task force must determine what would happen to the cost estimates if the useful life of the capital equipment were as short as three years or as long as seven years. Another concern was that the useful life of the equipment depended on the alternative chosen; that is, there would be less wear and tear under Alternative 1 than under Alternative 2. Finally, the task force must assess the impact of a purchase discount: Would the discount amount influence the ultimate decision? You believe that performing a sensitivity analysis on the number of procedures would be helpful, but you realize this task would require recalculation of the per unit cost inputs, an effort thought to be too time-consuming to undertake at this point in the analysis.

Redo the analysis if the per unit supplies cost; billing and collection cost; general administration cost; and transportation, setup, and breakdown costs are higher than the base case values by 10 percent. Redo the analysis again assuming these costs are 20 percent higher than the base case values.