attached photos are of the same question

. (1) In the following network, you can assume that all router interfaces have already been configured with correct IP address according to the following address table Routing has also been configured in all routers allowing traffic to go from one network to another network DHCPv4 Server 1 has already been configured to provide dynamic IP address allocation to network 192.168.5.0/24 R1 (the router itself) has already been configured to provide dynamic IP address allocation to network 192.168.2.0/24 You are asked to provide the necessary additional configuration commands to be done in one or some of the router(s) so that (1) Clients in network 192.168.5.0/24 will be able to receive dynamic IP address allocation from DHCPv4 Server 1 (2) Clients in network 192.168.2.0/24 will be able to receive dynamic IP address allocation from R1 (You have to specify which router are you going to configure otherwise marks will be deducted) Address Table Router 1 (R1) Router 1 (R1) Router 1 (R1) Router 1 (R1) Router 2 (R2) Router 2 (R2) Router 2 (R2) Router 2 (R2) Router 3 (R3 Router 3 (R3) Router 3 (RB Interface G0/0 G0/1 GO/2 G0/3 G0/0 G0/1 G0/2 G0/3 G0/0 G0/1 GO/2 IP address 192.168.1.1 200.200.11 200.200.1.9 192.168.4.1 192.168.2.1 200.200.1.2 200.200.1.6 192.168.5.1 192.168.3.1 200.200.15 200.200.1.10 Network Address 192.168.1.0/24 200.200.1.0/30 200.200.1.8/30 192.168.4.0/24 192.168.2.0/24 200.200.1.0/30 200.200.1.4/30 192.168.5.0/24 192.168.3.0/24 200,200.1.4/30 200.200.1:8/30 192.168.1.0/24 192.168.2.0/24 192.168.2.1 GO/O 192.168.1.1 GO/O 200.200.1.0/30 GO/3 192.168.4.1 R1 R2 GO/1 .1 G0/1 .2 GO/3 192.168.5.1 GO/2 .9 GO/2 .6 192.168.4.0/24 200.200.1.8/30 200.200.1.4/30 192.168.5.0/24 G0/2 G0/1 .5 .10 R3 G0/0 192.168.3.1 192.168.3.0/24 DHCPVA Server 1 192.168.3.9