Benton Corporation produces two grades of non-alcoholic wine from grapes that it buys from California growers. It produces and sells roughly 3,000,000 liters per year of a low-cost, high-volume product called CoolDay. It sells this in 600,000 5 -liter jugs. Benton also produces and sells roughly 300.000 liters per year of a low-volume, high-cost product called LiteMist. LiteMist is sold in 1 -liter bottles. Based on recent data, the CoolDay product has not been as profitable as LiteMist. Management is considering dropping the inexpensive CoolDay line so it can focus more attention on the LiteMist product. The LiteMist product already demands considerably more attention than the CoolDay line. Jack Eller, president and founder of Benton, is skeptical about this idea. He points out that for many decades the company produced only the CoolDay line and that it was always quite profitable. It wasn't until the company started producing the more complicated LiteMist wine that the profitability of CoolDay declined. Prior to the introduction of LiteMist, the company had basic equipment, simple growing and production procedures, and virtually no need for quality control. Because LiteMist is bottled in 1-liter bottles, it requires considerably more time and effort, both to bottle and to label and box than does CoolDay. The company must bottle and handle 5 times as many botties of LiteMist to sell the same quantity as CoolDay. CoolDay requires 1 month of agings LiteMist requires 1 year. CoolDay requires cleaning and inspection of equipment every 10,000 liters; LiteMist requires such maintenance every 600 liters: Jack has asked the accounting department to prepare an analysis of the cost per liter using the traditional costing approach and using activity-based costing. The following information was collected. Answer each of the following questions. Under traditional product costing using direct labor hours, compute the total manufacturing cost per liter of both products. (Round answers to 3 decimal ploces, es. 12.250.) eTextbook and Media Attempts: unlimited Under ABC, prepare a schedule showing the computation of the activity-based overhead rates (per cost driver). (Round overhead rotes to 3 decimal ploces, es 12.250 ) Prepare a schedule assigning each activity's overhead cost pool to each product, based on the use of cost drivers. Include a computation of overhead cost per liter. (Round overheod rate, cost per liter to 3 decimal places, eg. 12.250 and cost assigned to 0 decimal places, e\&. 12,250.) Compute the total manufacturing cost per liter for both products under ABC. (Round overhead cost per liter to 3 decimal places, eg. 1.225.)