Calculate dimensions A through N. M 1.5 TYP R1/2 0.625 TYP -R1/2 TYP 1.00 6.25 7.00 -0.56 TYP 0.66 1/4R M 7.75 K 1.750 2.600 TYP 1.00 +000 001 01.000 +000 002 01.200 CBORE X 0.13 DEEP 0.750 NOTES: 1. FINISH WHERE SHOWN 2. REMOVE ALL SHARP EDGES 3. UNSPECIFIED RADII TO BE 1/4 R 4.0 3.000 N ----- (1.0) 2.000 0.875 -B ALL DIMENSIONS IN INCHES UNLESS OTHERWISE SPECIFIED TOLERANCES UNLESS OTHERWISE SPECIFIED FRAC +1/32 XX +0.000 XXX +/-0.010 XXXXX +/-0.005 ANGLES +-1/2 VISE BODY DATE 7-4-99 B 1402 SCALE NTS DRAWN BY MLB REV 0 1 of 1 Calculate M Choose... + Calculate A Choose... 0.75 Calculate D 1.250 Calculate G 1.00 0.125 Calculate C 3.0 Calculate J 1.12 0.25 1/2 Calculate N 0.5 Calculate H 1.725 0.563 Calculate E 0.94 If a part fits into the 1.000 diameter hole is 1.002, what is the allowance ? Number Only with decimal. R1/2 0.625 TYP 6.25 1.5 TYP -R1/2 TYP N 7.00 -0.56 TYP 0.66 1/4R -1.00 7.75 125/ M K 10 000 -001 01.000 +.002 000 1.250 000 -002 01.200 1.750 2.600 TYP L0312 -1.00 NOTES: 1. FINISH WHERE SHOWN 2. REMOVE ALL SHARP EDGES 3. UNSPECIFIED RADII TO BE 1/4 R CBORE X 0.13 DEEP 0.750 4.0 3.000 2.0 N (1.0) 2.000 ALL DIMENSIONS IN INCHES UNLESS OTHERWISE SPECIFIED TOLERANCES UNLESS OTHERWISE SPECIFIED FRAC +1/32 XX +0.000 TITLE B VISE BODY 7-4-99 DRAWN BY MLB DWG NO B 1402 SHEET REV 0 1 of 1 XXX +-0.010 XXXXX +0.005 ANGLES +-1/2 DATE SCALE NTS