can you pleasd correct the mistakes

2. Prepare an analysis for Sonimad Sawmill, Incy to compare processing the decorative pieces further as it presently does, with selling the rough-cut product immediately spit-off. Feedack 7 Check My Wark 1. Analyze the firm and give calculations. Review methods. c. Estimated net realizable value method. When required, round decimal values to four places before converting to a percentage. For example, -88349 wotild be round to .8835 and entered as 88.35 percent. I more Check My Work uses remaining c. Estimated net realizable value method. When required, round decimal values to four places before converting to a percentage. Foe example, .88349 would be rounded to .8835 and entered as 788.35 percent. The studs are sold as roughicut lumber after emerging from the sawmill operation without further processing by SSI. Also, the posts require no further processing. The decorative pieces must be planed and further sized after emerging from the 551 sawmill, This additional processing costs 5515100,000 per month and nomally resuits in a lass of 10 percent of the units entering the process. Without this planing and sizing process, there is still an active intermediate market for the unfinished decorative pieces where the sales price averages $60 per unit. Required: 1. Based on the infarmation given for Sonimad Sawmill, Inc, allocate the foint processing costs of $1,020,000 to each of the three product lines using the: a. Relative sales-value-at-split-off method. When required, round decimal values to four places before converting to a percentage. For example, is8349 would be rounded to, 8835 and entered as 88.35 percent. Product vicld and average sales value on a per-unit basis from the joint process are as follows: The studs are sold as rough cut lumber after emerging from the sawmill operation without further processing by 5SI, Also, the posts require no further processing. The decorative pieces must be planed and further sized after emerging from the 551 sawmill. This additional processing costs 5515100,000 per month and normally results in a lass of 10 percent of the units entering the process. Without this planing and sizing process, there is still an active intermediate market for the unfinished decorative pleces where the sales price averages $60 per unit. Required: 1. Based on the information given for Sonimad Sawmili, Inc, allocate the joint processing costs of $1,020,000 to esch of the three product lines using the: a. Relative sales-value-at-spitit-off method. When required, round decimal values to four places before converting to a percentage, For example, , 88349 would be rounded to .8835 and entered as 88.35 percent. Sonimad Sawmill, Inc. (SS1), purchases logs from independent timber contractors and processes them into the following three types of lumber products: 1. Studs for residential construction (e.9. walls and ceilings) 2. Decorative pieces (e.9. fireplace mantels and beams for cathedral cellings) 3. Posts used as support braces (e.g. mine support braces and braces for exterior fences around ranch properties) These products are the result of a joint sawmill process that involves removing bark from the logs, cutting the logs into a workable size (ranging from 8 to 16 feet in length), and then cutting the individual products from the logs, depending upon the type of wood (pine, oak, wainut, or maple) and the size (diameter) of the log. The joint process results in the following costs and output of products during a typical month: Joint production costs: Product yield and average sales value on a per-unit basis from the joint process are as follows