Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

Can you please help me to solve this lab. I already took all the readings with the equipment as you can see in Image 3

Can you please help me to solve this lab.

I already took all the readings with the equipment as you can see in Image 3 and 6.

now i need help with the analysis and in image 3.

I would really appreciate that.

Thankyou!

image text in transcribedimage text in transcribedimage text in transcribedimage text in transcribedimage text in transcribedimage text in transcribedimage text in transcribed
ProjectileMotion-Lab.cap' Edit Workbook Display Journal Help Set Up Procedure * Activity-1.Data Analysis.1 Activity 2 Activity-2 Data Analysis-2 Bois 1. Plug the photogate closest to the launcher into Digital Input 1 on the 850 Universal Setup Interface. Plug the other photogate into Digital Input 2. The second photogate is located at a Summary distance of 0.Im away from the first photogate (The program calculates the initial speed by assuming the photogates are separated by 10.0 em and dividing by the time the ball takes to Calibration travel between the two gates). calculator 2. Plug the Time of Flight Accessory into Digital Input 3. 3. Place the projectile launcher close to your computer screen. Make sure a distance of about a meter is clear on the table/floor in the direction the ball will be fired. 4. Using the attached plumb bob, adjust the angle of the launcher to 0 launched horizontally from a height above the table). 5. Make sure to align the photogates beam hole with the pall. 6- Check to see that there is no one down range! Launch ling straight upward on the string. Don't jerk. Observe where the ball hits the table. Tape a small piece of tape to the table to mark the spot. Tape a sheet of blank paper at the location where the ball landed. Place the Time of Flight Accessory. 7. Click on the Record button. 00:25.00 Centrals * Common Rate 12:58 PM 3/7/2023 DELLProjectileMotion-Lab.cap" e Edit Workbook Display Journal Help O . GO Procedure Activity-1-Data & Analysis-1 Activity 2 Activity 2 Data, Analysis-2 Tools Horizontal Launch Speed Horizontal Launch Time of Flight Initial Speed Ch 0& 1& 2 (m/s) Run #15 A Time Of Flight Ch 0& 1&2 (s) Run #15 5.06 m/s 0.221s calibration Time of Flight vs Initial Speed Error_Ax=(([Exp-Ax (m)]-[Theoritical_Ax (m)])/[Theoritical_Ax (m)])*100 Vin TOF Averrage-Vin Average-t Exp-4y Exp-Ax Theoritical_Ay Theoritical_Ax Error_Ay Error_Ax Clicks (m/s (5 ) (m/s ) (S) (m) (m) (m) (m) (9%) (9%) 1 3 6.87 0.231 6 873333333 0.2260 0.25 1.5 2 0.222 6.873333333 0.2260 0.25 1.55 3 3 6.86 0.225 6 873333333 0.2260 0.25 155 4 2 5 08 0.223 5/073333333 0.2220 0.24 1.13 5 2 5 08 0 222 5.073333333 0.2220 0.24 1.13 6 2 5.06 0.221 5.073333333 0.2220 0.24 1. 13 7 1 3.32 0. 214 3.320000000 0.2157 0.23 0.72 1 3.32 0.216 3,320000000 0.2157 0.23 1.72 9 3.32 0.217 3.320000000 0.2157 0.23 0.72 1:0 00:00.00 Common Rate u Recand re 1:03 PM O 3/9/2123 DELLotion Lab.cap" Workbook Display Journal Help Set Up Procedure Activity-1-Data Analysis-1 * Activity 2 Activity.2 Data Analysis-2 Data analysis for activity 1: 1. Will the Time of Flight for the two click position (horizontal fire) be more than, less than, or the same as the Time of Flight for the three click position? Explain your logic! 2. Did the time of flight depend on the initial horizontal speed? What does this imply about the dependence of the vertical motion on the horizontal motion? 3. How well did your predicted range compare to the actual range? What does this show? L 4. How would the horizontal range change if the muzzle velocity was doubled? Explain how you know. 5. How would the horizontal range change if the height from the ground was doubled? Explain how you know. 6. How would the horizontal range change if the mass of the ball was doubled? Explain how you know. 7. What effect are we able to ignore in this experiment? Explain. ELL- ProjectileMotion-Lab.cap" File Edit Workbook Duplay Joumal Help set Up Procedure Activity-1-Data Analysis-1 Activity 2), Activity-2 Data Analysis-2 Toola Launching at an angle from a height Measure the projectile range: Ro Equipment Setup (computer is not used in this activity ) we use carbon paper: summary 1. Using the same setup of Activity 1 experiment, (keep time of flight connected but dont Calibration use it). 2. Adjust the angle of the launcher to 10. 3. Drop a plumb line from the Launch Position of Ball circle and mark the position with a piece of tape. Measure the distance Ax from this mark to the landing position for each angle. 4. Use Lona range only. as far as possible into the Launcher. Make sure three click Keep track of the location on the floor where the ball land 6. Tape a sheet of blank paper at this location. Place carbon paper over the blank paper. Control 00:25.00 Common Rate THE O 12:58 PM 3/7/203 DELLtion Lab.cap Jerkbook Display Joumal Help set Up Procedure Activity-1-Data Analysts-1 Activity 2 Activity-2 Data * Analysis-2 [ Digits title here] Initial Speed Ch 0& 1& 2 (Its Run #42 TRange ERange 6.69m/s Set Range vs Angle EN Tflight=([Vcor (m/s )]'s in([Angle (")])+(([Vcor (m/s)]*s in([Angle (")] 0 Angle V3 Vcor AY Tflight TRange ERange Diff (9) (m/s ) (m/s (m) (s) (m) (m) Quadratic Ax' + Bx + C 0 6.75 6.75 -0.259 0.230 1.55 1:589 2.43 A = -0.00172 + 1.4x10- Quadratic 10 6.82 6180 -0.259 0.380 2.55 2.538 -0.32 4 B = 0.149 + 0.0087 Ax' + Bx + C C = 1.40 + 0.12 = -0.00136 + 1.2x10 20 6.76 6.73 -0.259 0.563 3.56 3.488 -2.04 RMSE = 0.114 B = 0.135 + 0.0077 30 6.67 6 62 0.259 0.746 4.28 4.354 1 72 C = 1.47 + 0.11 35 6.68 6.63 -0. 259 0.838 4 55 4.640 1.98 RMSE = 0.100 40 6.69 5 63 0.259 0.926 4.70 4.774 1.48 45 6.66 6 59 -0.259 1.004 4.68 4.799 2.56 -20 20 40 60 80 100 120 50 6.72 5.65 0.259 1,087 4.65 4.702 1.17 Angle () 60 6.69 6.61 -0.259 1 211 4.00 4.663 16.52 oh title here ] 00:00.00 Common Rate ~ H Ready 1:01 PM O BELLileMotion-La File Edit Workbook Display Journal Help set Up Procedure Activity-1-Data Analysis-1 Activity 2 Activity-2 Data Analysis -2 Tools Data analysis for activity 2: Calibration 1. Verify that the calculations for the Measured Range (using meter stick) agree with Equation Calcularmy dans itor 2. How well your plot Range vs. Angle agreed with your theoritical plot. 3. What's your conclusion? Comtrain N 00:25.00 12:31 PM O DELLjeculeMotion-Lab.cap Edit Workbook Display Sournal Help set Up > Procedure Activity-1.Data Analysis-1 Activity 2. Activity-2 Data Analysis-2 itup I. : Equipment, Experimental Procedure, Data Taking and Preliminary Data A Analysis calibration a) Equipment needed: 1. Interface 850 2. The Ballistic Launcher (with a plas 3. Two one meter sticks Coda 4. Two photogates 5. Time of flight 6. Carbon paper and a white paper b) Experimental Procedure & Data Taking: In this experiment, a spring-loaded gun fires a plastic 1 a tabletop. You need to measure and in the same time calculate the range of the projectile, using the measured value of the initial speed and the height of the ball with respect to the landing position. 1. Mount and Connect two photogates to the 850 Universal Interface. 4. Set up the launcher near the two photogates. Carefully adjust the launcher to fire horizontally. O 00:25.00 Common late ~ H O 12:50 PM 3/7/2023 DELL

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Physics Principles With Applications ()

Authors: Douglas C. Giancoli Page

5th Edition

0136119719, 9780136119715

More Books

Students also viewed these Physics questions

Question

Let U U(0, 1). Let a and b be constants with a Answered: 1 week ago

Answered: 1 week ago

Question

Explain the process of MBO

Answered: 1 week ago

Question

5. How can I help others in the network achieve their goals?

Answered: 1 week ago