Capability Analysis Summary Report for D1 How capable is the process? Capability Analysis for d1, in Summary Report Customer Requirements Z potential = 0.64 Low Z actual = -0.36 High Upper spec Target Lower spec 0.705 0.7 0.695 Process Characterization Does the process mean differ from 0.7? Mean 0 0.05 0.1 > 0.5 Standard deviation (overall) 0.6992 0.010621 Yes No Actual (overall) capability P = 0.453 Pp Actual (Overall) Capability Are the data inside the limits and close to the target? LSTargUSL 0.60 0.62 0.64 0.66 0.68 0.70 0.72 Ppk Z.Bench % Out of spec PPM (DPMO) Comments 0.16 0.13 -0.36 63.88 638759 The process mean does not differ significantly from the target (p > 0.05). The defect rate is 63.88%, which estimates the percentage of parts from the process that are outside the spec limits. Actual (overall) capability is what the customer experiences. Potential (within) capability is what could be achieved if process shifts and drifts were eliminated. Capability Analysis for d1, in Process Performance Report Capability Histogram Are the data inside the limits and close to the target? LargeSL Process Characterization Total N Subgroup size Mean Standard deviation (overall) Standard deviation (within) 100 1 0.6992 0.010621 0.0043655 Capability Statistics Actual (overall) Pp 0.16 Ppk 0.13 Z.Bench -0.36 % Out of spec (observed) 7.00 % Out of spec (expected) 63.88 PPM (DPMO) (observed) 70000 PPM (DPMO) (expected) 638759 Potential (within) Cp 0.38 Cpk 0.32 0.60 0.62 0.64 0.66 0.68 Z.Bench 0.64 0.70 0.72 % Out of spec (expected) 26.00 PPM (DPMO) (expected) 259989 Actual (overall) capability is what the customer experiences Potential (within) capability is what could be achieved if process shifts and drifts were eliminated. Moving Range Individual Value 0.70- 0.65- 0.60 0.10- 0.05 0.00 21 31 Capability Analysis for d1, in Diagnostic Report I-MR Chart Confirm that the process is stable. Normality Plot The points should be close to the line. 51 81 91 Results P-value Normality Test (Anderson-Darling) Fal < 0.005