Chose the right answer from the options table. Note: The items MUST be entered as an exact match to those in the options table with no typos! 1. By using 2. With you can limit the number of MAC addresses that can be assigned dynamically to a port. a private IP address can be translated by a single public address. 3. Both switches connect with a cross-over cable. The interface on one switch is set on Trunk and the other switch has default settings. The other switch interface mode will be changed to automatically. begins negotiation message to dynamically to start using trunking. 4. In switchport modes, 5. is one of the VLAN benefits. 6. By default, switch interfaces are set to the 7. mode. command is used to check end-to-end connectivity by showing all hops (routers) in between. 8. The preferred type of mask used with OSPF configuration is the 9. The command set on. 10. The command mask. shows only the parameters for the access-list 110. This command does not show the interface the list is shows which interfaces have access lists set. Options Table: Bandwidth PAT NAT Router-on-a-stick Shrink Broadcast Domain Traceroute Ping Network show access-list 110 0 Access Trunk show ip interface 1 show ip access-lists show ip interface brife Data Link show access-lists Wildcard Subnet Port Security Flow Control Token Passing Dynamic Auto show ip access-list 110 Token Passing Time-out Loopback Dynamic Desirable Supernet