CIRC-04 (no need to type everything in just) File > Sketchbook > Examples > Library-Servo > Sweep (example from the great arduino.cc site check it out for other great ideas) // Sweep il by BARRAGAN #include Servo myservo; // create servo object to control a servo int pos = 0; // variable to store the servo position void setup() { myservo.attach(9); // attaches the servo on pin 9 to the servo object { void loop() { for(pos = 0; pos =1; pos-=1) // goes from 180 degrees to 0 degrees myservo.write(pos); // tell servo to go to position in variable 'pos' delay(15); Il waits 15ms for the servo to reach the position 1. What does the project do? 2. What code declares variables? 3. What code inputs data? 4. What code outputs data? 5. What code makes calculations? 6. What code uses and if-then-else statement? (if any)