Connect the middle 8 LEDs on the 10-wide red LED pack to the pins 30-37 of the Arduino with the 11-pin SIP resistor pack. See schematic below. Pay attention to which pin is which on the LED pack and resistor pack. If you do not know - consult documentation or design an experiment to measure. The sketch you ran before can turn a single LED on or off. Write a program to make the LEDs blink in the following sequence: a) Turn one LED on at a time for 0.25 second and then turn it off. Repeat this for the other LEDs so that only one LED is lighted at a time. Light the LEDs from right to left. Then turn all LEDs on together for 0.8 seconds and then turn them off. Repeat indefinitely