FREE Trial
Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

Consider a 6.0 g steel nail 8.0 cm long and a hammer that exerts an average force of 600 N on the nail when it

Consider a 6.0 g steel nail 8.0 cm long and a hammer that exerts an average force of 600 N on the nail when it is being driven into a piece of wood. The nail becomes warmer. What is the nail’s final temperature is? The specific heat capacity of steel is 450 J/kg °C


Step by Step Solution

★★★★★

3.49 Rating (166 Votes )

There are 3 Steps involved in it

Step: 1

As we know that Equation of work done W Fd Where Fforce applied ... blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Fundamentals of Physics

Fundamentals of Physics

Authors: Jearl Walker, Halliday Resnick

8th Extended edition

471758019, 978-0471758013

More Books

Students also viewed these Physics questions

Question

★★★★★
Is fraud more likely to occur when it is being committed by top-level employees? Explain.

Answered: 1 week ago

Question

★★★★★
What kind of people served on the IASC when it was initially established?

Answered: 1 week ago

Question

★★★★★
Explain how to center a window on the screen when it is created with the window.open() method.

Answered: 1 week ago

Question

★★★★★
The two roots of a quadratic equation ax 2 + bx + c = 0 can be obtained using the following formula: b 2 - 4ac is called the discriminant of the quadratic equation. If it is positive, the equation...

Answered: 1 week ago

Question

★★★★★
With reference to Example 13.2, verify that the P-value corresponding to the observed value of the test statistic is 0.0808. Example 13.2 Suppose that 100 high-performance tires made by a certain...

Answered: 1 week ago

Question

★★★★★
Describe the extent and nature of the challenges facing the workplace in the next decade.

Answered: 1 week ago

Question

★★★★★
Discuss the roles of metacognition in learning and remembering.

Answered: 1 week ago

Question

★★★★★
The difference between practical capacity and master-budget capacity utilization is the best measure of managements ability to balance the costs of having too much capacity and having too little...

Answered: 1 week ago

Question

★★★★★
You observe the following yield curve for risk-free government zeros: You believe the yield curve will remain the same over the next 20 years, and you decide to buy 6year zeros, and sell them after 3...

Answered: 1 week ago

Question

★★★★★
Find each function f(x) given, (a) find any three ordered pair solutions (a,b), then (b) algebraically compute f(x), and (c) verify the ordered pairs (a,b) satisfy f(x). f(x)=x-2 f(x)=x +3 f(x) = x +...

Answered: 1 week ago

Question

★★★★★
Homework. Design a journal bearing for a centrifugal pump from the following data: Assume the diameter of the journal d as 100 mm and take 1= 150 mm; Load on the journal = 10 000 N; Speed of the...

Answered: 1 week ago

Question

★★★★★
Draw a line graph for each data set in Problems 36-39. Data set D Data set A: The annual wages of employees at a small accounting firm are given in thousands of dollars. 25 16 25 25 14 18 1 2 2 2...

Answered: 1 week ago

Question

★★★★★
A 20% ethylene glycol solution is flowing through a 4-nom sch 80 commercial steel pipe. The pipe is 350 ft long and is horizontal. The pressure drop through the pipe is 4 psi. The ethylene glycol is...

Answered: 1 week ago

Question

★★★★★
Figure P33.1 shows eight point sources of light, \(a-h\), and two detectors, A and B. The point sources are evenly spaced, with \(0.10 \mathrm{~m}\) between adjacent sources, and detector A shields...

Answered: 1 week ago

Question

★★★★★
Find the maximum energy (E) stored in the inductor of Example 10.17 (a) and show that it is greater than the sum of the maximum stored energies (E 1 and E 2 ) when each source is applied alone....

Answered: 1 week ago

Question

★★★★★
Consider the system shown in Fig. 9.54 in which a harmonic force acts on the mass \(m\). Derive the condition under which the steady-state displacement of mass \(m\) will be zero. Disc, mass M 000 R...

Answered: 1 week ago

Question

★★★★★
3. Keaubie Co.,Inc. purchased a building with a fair market value of $75,000 by issuing 30,000 shares of $2 par value common stock

Answered: 1 week ago

Question

★★★★★
Consider a closed, rigid tank with a volume of 0.8L, filled with cold water initially at 27C. The tank is filled such that there are no voids (air pockets) within. The initial pressure within the...

Answered: 1 week ago

Question

★★★★★
A particle moves along a straight path through displacement d = (8 m)i + cj while force F = (2 N)i (4N)i acts on it. (Other forces also act on the particle.) What is the value of c if the work done...

Answered: 1 week ago

Question

★★★★★
Figure shows three rotating, uniform disks that are coupled by belts. One belt runs around the rims of disks A and C. Another belt runs around a central hub on disk A and the rim of disk B. The belts...

Answered: 1 week ago

Question

★★★★★
Calculate the work done by an external agent during an isothermal compression of 1.00 mol of oxygen from a volume of 22.4 L at 0oC and 1.00 atm to a volume of 16.8 L.

Answered: 1 week ago

Question

★★★★★
How does an evolutionary explanation differ from a functional explanationpg99

Answered: 1 week ago

Question

★★★★★
1. Is consciousness usefulpg99 That is, what (if anything) can we do because of consciousness that we couldnt do otherwisepg99

Answered: 1 week ago

Question

★★★★★
13. Suppose you suffer a cut through the spinal cord on the right side only. For the part of the body below that cut, will you lose pain sensation on the left side or the right side? Will you lose...

Answered: 1 week ago

Previous Question Next Question