Consider the following data for two products of Vigano Manufacturing. Activity Machine setup Parts handling Quality inspections Total budgeted overhead Unit Information Budgeted Cost Activity Driver $ 18,000 (20 machine setups) 14,400 (16,000 parts) 21,600 (100 inspections) $ 54,000 Units produced Product A 1,800 units Direct materials cost $ 28 per unit Product B 360 units $ 38 per unit $ 48 per unit 2 per unit $ 58 per unit 2.50 per unit Direct labor cost Direct labor hours 1. Using a plantwide overhead rate based on 4,500 direct labor hours, compute the total product cost per unit for each product. 2. Consider the following additional information about these two products. If activity-based costing is used to allocate overhead cost, (a) compute overhead activity rates, (b) allocate overhead cost to Product A and Product B and compute overhead cost per unit for each, and (c) compute product cost per unit for each. Actual Activity Usage Setups Parts Inspections Product A 8 setups Product B 12 setups 40 inspections 6,000 parts 60 inspections 10,000 parts Complete this question by entering your answers in the tabs below. Required 1 Required 2 Consider the following additional information about these two products. If activity-based costing is used to allocate overhead cost, (a) compute overhead activity rates, (b) allocate overhead cost to Product A and Product B and compute overhead cost per unit for each, and (c) compute product cost per unit for each. (Round your final answers to 2 decimal places.) a. Compute overhead activity rates Machine setup Activity Parts handling Quality inspection Activity Rate per setup per part per inspection b. Allocate overhead to Product A, B and compute overhead cost per unit Activity Machine setup Parts handling Quality inspection Total allocated cost Units produced Overhead cost per unit Allocated Cost Product A Product B c. Product cost per unit using activity-based costing Per Unit Product A Product B Product Cost per Unit < Required 1 Required 2 > Show less A