Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Consider the pulley assembly below. A torque of 500 Nmm is applied to the end of a 2mm diameter shaft, which is transmitted to
Consider the pulley assembly below. A torque of 500 Nmm is applied to the end of a 2mm diameter shaft, which is transmitted to pulley A, which has a radius of 5 mm. Pulley A has a fan belt under tension, which is angled 20 down from the z axis. The belt tension on the loose side of Pulley A is 25% of that on the tight side. Assume the shaft is running at a constant speed. (a) Determine the belt tensions on the Pulley A. (b) Identify the critical location along the shaft. (c) Identify the critical element location on the cross-section by drawing a dot on the figure in the answer box. (d) Calculate the maximum bending stress state and torsional shear stress of the shaft. (e) Calculate the Principal Stresses and Maximum Shear Stress of the critical element. Report your final answers here: T=500 Nmm C (a) T = N T2= N (b) x mm T2 B (d) Obend MPa A Ttorsion MPa (e) = MPa T 02= MPa 03= MPa Tmax= MPa 15 mm 5 mm
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started