Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

Consider transmission of two control protocol messages: the Internet Control Message Protocol ( ICMP ) and the Address Resolution Protocol ( ARP ) message. The

Consider transmission of two control protocol messages: the Internet Control Message Protocol (ICMP) and the Address Resolution Protocol (ARP) message. The formats of these messages are shown in Figure 2.1 below:
Figure 2.1
(i) Which layer is responsible for processing these messages? Does this mean that ICMP and ARP provide service to this layer, i.e. that they belong to the lower layer?
(ii) Explain how the ICMP and ARP messages are transmitted. What is similar and what is different for each of the messages?
(iii) Consider two messages: 1. An ICMP message of a minimum possible size sent by a host. 2. An ARP reply message sent by a gateway router. Messages are transmitted
by a classical Ethernet. Determine the size of the Ethernet frame in each case.
(b) Four networks N1 N4, which use Classless Inter-Domain Routing (CIDR) addressing protocol, have the following IP base addresses for each network, respectively:
N1-75.16.96.0/21
N2-75.16.104.0/21
N3-75.16.112.0/21
N4-75.16.120.0/21
The index /21 indicates the length of the corresponding mask.
Question 2 continues...
[10%]
[10%]
[10%]
5 CE707-7-AU
Question 2(continued)
(i) If all these networks are connected to the same router, can this router advertise outside to the other routers the aggregated address? If so, derive the aggregated
address and the corresponding mask. If no, explain why.
(ii) The address aggregation technique helps routers to speed up processing of the received packets. Explain why the aggregation speeds up processing of the received
packets.
(iii) If a packet with the IP destination address IPX =75.16.125.15 arrives at the router, to which of the four networks will the packet be routed? Explain in detail why.
(iv) Determine the range of the IP addresses in each of the networks, i.e. find the smallest and the biggest address in each network domain.
(c) Suppose that host A communicates via router R with hosts B and C in the IPv4 network shown in Figure 2.2. Suppose that a TCP message that contains 1200 bytes of data and 20 bytes of TCP header is passed to the network layer of the host A. Host A sends two separate IP packets for delivery to B and C, respectively. The link R - B has MTU1=600 bytes, the link R - C has MTU2=1220 bytes.
Figure 2.2
(i) Is fragmentation of the packet required for each transmission? Explain your answer.
(ii) In case if either or both of the packets require fragmentation, in each case, calculate: the payload, the value of fragment offset, and show the value of the M-bit for all
fragments.
(iii) If the TCP message in host A contained 530 bytes of data and 20 bytes of TCP header, would the IP packet be fragmented in any IPv4 network with MTUs which
are different from the MTUs we use in this problem? Explain your answer.
image text in transcribed

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Big Data Fundamentals Concepts, Drivers & Techniques

Authors: Thomas Erl, Wajid Khattak, Paul Buhler

1st Edition

0134291204, 9780134291208

More Books

Students also viewed these Databases questions