Answered step by step
Verified Expert Solution
Question
1 Approved Answer
CSC 7 2 2 Data Communications and Networking Semester 1 - 2 0 2 4 Network Addressing Lab [ 1 0 0 marks ] weighting:
CSC Data Communications and Networking
Semester
Network Addressing Lab marks weighting:
Due Date: @PM
Given below is a network topology that needs an addressing scheme and complete configuration so that there is
end to end connectivity. Using the addressing space of you are required to use it and subnet the
address to cater for the network. All addresses must be given in decimal form.
You will need to perform the following tasks:
Identify the number of subnets in the topology given.
Calculate the new subnet mask.
Calculate the number of hosts in each subnet.
Complete the table for each subnet: add rows as needed
Subnet
number
Subnet address First IP address Last IP Address Broadcast Address
Draw the topology in packet tracer. Clearly place notes to document the topology.
Start from subnet and assign addresses as follows:
a Default gateways last address in the subnet
b Router interfaces for WAN connections, use first and second address from the subnet.
c Pcs can have any address within the subnet.
Router configuration for all routers. Document the configurations.
a Configure hostnames
b Configure motd
c Configure line vty
d Configure line console
e Configure interface addresses
f Configure static routing to enable end to end communication
g Save changes on router
PC must be configured to connect to Access point
Complete the addressing table.
Device interface IP Address Subnet Mask Default
gateway
Nadi Router
Lautoka Router
Suva Router
PC
PC
PC
PC
PC
PC
PC
For each router, provide the routing table in this format; add rows as needed
Destination Network
Address
Exit Interfaceinterface
address
Number of hops
Marking Guide:
Task Allocated marks Marks Obtained
Number of subnets
New subnet mask
Number of hosts in each
subnet
Subnet table completion
Packet tracer diagram and
its documentation notes
Addressing of network in
packet tracer
Router configuration for all
routers and its
documentation
Access point and its
connectivity
Addressing table
completion
Routing table completion
Total
Submission
Work in pairs only.
A pdf format report showing the details of configurations include snapshots of all configurations tables etc..
Packet tracer file properly documented
The names to be used as follows:
AxxxxxxxxAxxxxxxxLabRptpdf
AxxxxxxxxAxxxxxxxLabPktpka
Do not zip the files.
Use packet tracer version or latest for this lab.
Late Submission
Start EARLY. Also when you finish dont hold on to your assignment till the last moment. Submit as soon as you
are satisfied with it
Marks will be deducted on daily basis if submitted late. per day of the marks received. However, you must
notify the lecturer through an email or verbally communicate the reasons for delay. Medical sick leaves will not
be catered for assignment delays unless you can prove with a valid medical sick sheet that you were admitted
throughout the period of submission. For example, if the assignment is supposed to be submitted on nd April,
then it must be submitted before midnight. If your submission is after midnight, then you lose of the marks
received.
Plagiarism refer to Section of University Academic & Student Regulations UASR
The end
All the best..
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started