2- Add the following runout tolerances and datums to the figure below: (a) The o1.187 in. is to be datum C. (b) A 1.20-in. length starting 40 in, from the right end of the part is to be datum D. (c) Runout tolerances are related to the axis established by datums C and D. (d) A total runout tolerance of .005 in. between positions A and B. (e) A circular runout tolerance of .002 in. for diameters E and F. (f) A circular runout tolerance of .005 in. for diameter G. (g) A circular runout tolerance of .004 in, for surface H. (h) A circular runout tolerance of .003 in. for surfaces J and K. 6.00 80 1.30 :34 01.30 03.00 813 1.187 O. 1.183 812 2.00 Page 2 of 2