eBook Single Plantwide and Multiple Production Department Factory Overhead Rate Methods and Product Cost Distortion The management of Nova Industries Inc. manufactures gasoline and diesel engines through two production departments, Fabrication and Assembly. Management needs accurate product cost information In order to guide product strategy, Presently, the company uses a single plantwide products, However, management is considering the multiple production department factory overhead rate method. The following factory overhead was budgeted for Nova: Fabrication Department factory overhead $494,000 Assembly Department factory overhead 190,000 Total $684,000 Direct labor hours were estimated as follows: Fabrication Department 3,800 hours Assembly Department 3,800 Total 7,600 hours In addition, the direct labor hours (dih) used to produce a unit of each product in each department were determined from engineering records, as follows Production Departments Gasoline Engine Diesel Engine Fabrication Department 1.20 dih 2:80 dih Assembly Department 2.80 1.20 Direct labor hours per unit 4:00 dih 4.00 dih a. Determine the per-unit factory overhead allocated to the gasoline and diesel engines under the single plantwide factory overhead rate method, using direct labor hours as the activity base. Gasoline engine 360 V per unit Diesel engine 360 V per unit b. Determine the per-unit factory overhead allocated to the gasoline and diesel engines under the multiple production department factory overhead rate method, using direct labor hours as the activity base for each department. Gasoline engine X per unit Diesel engine per unit C. Recommend to management a product costing approach, based on your analyses in (a) and (b). Management should select the multiple department V factory overhead rate method of allocating overhead costs. The single plantwide V factory overhead rate method indicates that both p multiple department rate method avoids