Exercise 6 Consider the figure below. Do the following: 1. Load the " flat end mill tool#4 (diameter 0.50). 2. Starting with a 4"x4"x0.5" and using Flashcut software, generate a G-code that 2"x3"x 0.2" centered pocket shown. 3. Take a screenshot of the "Create Pocketing Operation" window where all of the parameters are specified. 4. Copy and paste the G-code in the word document. 5. Run the G-code. 6. Take a screenshot of all three views of the machined part. 7. Copy and paste in the word document. Use your best judgement to assume any dimension or cutting parameter you de missing. Simple drilling cycle 81 Safe level = 0.2" Retract (R) level = 0 8. (Ctrl) -1.00- -2.00 4.00 20 3.00 400