Question
first, Design the decoder for the 8253, where A9-A2 =10101011 is used to activate CS.(Use NAND and inverters only. ) Then, from the address determines
first, Design the decoder for the 8253, where A9-A2 =10101011 is used to activate CS.(Use NAND and inverters only. ) Then, from the address determines the port address for each port of this design. Finally, you need to Find the control word to program counter 1 for mode 3, binary count, low byte first, followed by high byte. Use the port numbers and the control words Write a simple program. Assume that CLK1 = 1.6 MHz, after running the program, get the result OUT1 = 1200 Hz.
References: BARRY B. BREY, "THE INTEL MICROPROCESSORS: Architecture, Programming, and Interfacing", 8th Edition, Prentice Hall. -----These are all the details I have..
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started