Answered step by step
Verified Expert Solution
Question
1 Approved Answer
For the schematic shown, the cross-sectional areas of the cylinder and the rode are 10cm2 and 2Cm2 respectively, the back pressure is 1 bar, frictional
For the schematic shown, the cross-sectional areas of the cylinder and the rode are 10cm2 and 2Cm2 respectively, the back pressure is 1 bar, frictional force is neglected and the gravitational acceleration is 10m/S2. what will happen to the load when P1 is pressed? The resultanc forte is enough to raise the load but once it rabed the cylinder vall retroct slowly The resulian forte is enough so raise the load and it stayy raised The resultana sorce is noe enough vo raise the lobd, bus it would be if ne raise the pressure of the compressor to 8 bar, The opposing forces are the same as the theoretial force which will barely extend the cylinder
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started