The pipe shown in the figure is an idealized part of an industrial plant piping system. The pipe of outer diameter of 100 mm and a thickness of 5 mm is subjected to an internal pressure of 5.0 MPa and a transverse load of 1.0 kN at C in the -z direction. (The free body diagram of the pipe section is shown on the right and the pipe can be considered as a thin-walled pressure vessel). 1. Calculate the forces and moments acting at the critical section. (4pts) 2. Consider the pipe as a closed pressure vessel and find all the stresses acting on the critical element at A, on outer wall of pipe in the x-y plane. 3. Find the conservative safety factor if the pipe is made of hot rolled AISI 1020 steel. (12pts) (10pts) m MAY Fpress Oy = 210 MPa RAZ -5 MPa 50 mm 5 mm (b) 2 m I kN Max Raz Max Fpress Raz Fpression B C 1 kN Fpress.