Question: I appreciate any help with the following code issue: I need some help developing code to load into a Raspberry PI to control a home
I appreciate any help with the following code issue:
I need some help developing code to load into a Raspberry PI to control a home water leak detection system. The schematic of how the system should operate is posted below. The Raspberry PI is used to control the system, and operates on the feedback from the water detection sensors. Once the sensors detect water, the Raspberry is triggered to operate a water shutoff valve to prevent damage to the home. The Raspberry is also integrated with the home Wifi, and should send a text message to the home owner that a water leak has been detected. Please print in response as I have trouble reading peoples hand writing sometimes, thank you for your time !
Please use ladder logic so it can be loaded into the Raspberry. The point here is to allow the Raspberry to become the systems PLC.
All interface between sensors and Raspberry are direct connections to the Raspberry (sensors are not wireless). Water shutoff valve is also direct to Raspberry.

Home Water Main Raspberry PI (utilized as system PLC) Wifi connected Home 120V power Supply Remote Grove Water Sensor Honeywell "Automatic water shut off valve Home Water Main Raspberry PI (utilized as system PLC) Wifi connected Home 120V power Supply Remote Grove Water Sensor Honeywell "Automatic water shut off valve
Step by Step Solution
There are 3 Steps involved in it
Get step-by-step solutions from verified subject matter experts
