Question
1. Connect 8 LEDs with PORTD of the microcontroller. 2. All LEDs need to be grounded through current limiting resistors of 1 K ohm. 3.
1. Connect 8 LEDs with PORTD of the microcontroller.
2. All LEDs need to be grounded through current limiting resistors of 1 K ohm.
3. C-program the microcontroller such that it shows the 8-bit binary code of numbers from 0 to 255 on 8 LEDs, each with a delay of 1 second. LED connected to PD0 shall act as least significant bit of the binary code and LED connected to PD7 shall act as most significant bit.
4. After displaying binary code of 255, the circuit shall again start from 0 to 255.
Step by Step Solution
3.32 Rating (164 Votes )
There are 3 Steps involved in it
Step: 1
Recall binary numbers000 011 102 113 and goes on Leds well lit up in binary order Leds blinking pattern will be in binary form Leds will be connected to port1 of 8051 microcontroller I am going to mak...
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started
Systems analysis and design
Authors: kenneth e. kendall, julie e. kendall
8th Edition
135094909, 013608916X, 9780135094907, 978-0136089162
