I'm having a difficult time answering these questions

Analysis Questions: . Please answer the following questions in at least two complete sentences, unless otherwise indicated. 1. Fill in each blank with the correct calculated number to determine the limits of the specified tolerance: . For the 10- resistor, the resistance measured by the multimeter would be out of 5% tolerance if it were lower than _-2 or higher than _-2. . For the 47-2 resistor, the resistance measured by the multimeter would be out of 5% tolerance if it were lower than _-2 or higher than _-2. . For the 100- resistor, the resistance measured by the multimeter would be out of 5% tolerance if it were lower than _-2 or higher than _-2. . For the 220-2 resistor, the resistance measured by the multimeter would be out of 5% tolerance if it were lower than _-2 or higher than _-2. 2. Were all your resistors within the tolerance values? What could account for the differences of the measured resistance to the listed resistance? 3. Were the listed voltages of the batteries the same as the measured voltages? What could account for any differences in those measurements? 4. For Procedures 3 and 4, what was your group's smallest and largest % difference (or % error) values? What do you think were some sources of