In NAT points) configurati conflne llowing command was issued on global configuration mode: assumed by this command? (circle all that apply) Which of the following can be ofth config)# insidesource mand? (circle all 10 entries tessconfigat will be ip nat list 10 interface fa0/1 overload AT pool will contain 10 entries in the list. e inside global address is the IP address configured on b. Th fa0/1. C. Access list d, 10 specifies the inside local addresses that will be translated. This configuration is not using PAT. Interface fa0/1 is the inside interface. e. NAT trans 19 lates a private address 192.168.1.1 to a public IP address 12.150.146.100. How would 2.168.1.1 be described? (circle two) a. Inside b. Global c. Outside d. Local With dynamic NAT, performing translation for inside addresses only, what causes NAT table entries to be created? (circle one) a. Configuration using the ip nat inside source command. b. Configuration using the ip nat outside source command. c. The first packet from the inside network to the outside network. d. The first packet fro mthe outside network to the inside network. Which of the following are private addresses? (circle all that apply) a. 172.22.1.1 b. 10.255.1.1 c. 192.31.1.1 d. 10.1.255.1 e. 172.33.1.1 The internetworks created by Enterprises A and B both connect to the Internet, allowing all users to connect to hosts in the Internet and hosts in the other Enterprise. Enterprise C is totally isolated, not connecting to the internet or to other companies. Which of the following are true about the use of public and private IP addresses in this scenario? (circle two) a. Enterprises A and B can both use private network 172.16.0.0 as long as they also use NAT or PAT Enterprises A and B can both use private IP networks (IPv4), but they cannot use the same private network. b. c. Enterprise C can use any private IPv4 network. d. Enterprises A and B must assign public IPv4 addresses to all hosts in their respective internetworks