In-class assessment: Max 4.0hrs to complete and submit. In Packet tracer please design the network with the requirements below: Each router needs to have its own subnet. There also needs to be VLANs across the entire infrastructure. Each Segment will have an assigned VLAN (see diagram) which is associated with each switch. Inter VLAN configuration is required in order to forward traffic from one VLAN to another VLAN. No Static Routes or RIP/RIPv2 allowed. In addition to this the following must be configured below: 1) Hostnames for each device 2) Enable secret password (password MUST BE your firstname (lowercase)) 3) MOTD Example: Unauthorized access not permitted - Systems Admin jkanlagna@conestogac.on.ca 4) Addresses will be provided from DHCP configuration from network switch as per your vLAN assignment from your professor please exclude ranges X.X.X.1 to X.X.X.20 5) Communication between nodes from different networks must be evident (PINGABLE) 6) TELNET / SSH configuration for your network switch & router 7) Administratively shut down ports 20-24 8) Configure a TFTP server for each network with a static IP address, make a backup of your configuration for your router and switch AFTER youve completed all the above. Please use the naming convention of the file name below: - Switch = Firstname-Switch HOSTNAME-KW Example: JAMIE-CONSW1-KW - Router = Firstname-Router HOSTNAME-KW Example: JAMIE-CONR1-KW R1 Conestoga KW SE0/1/0 10.60.147.1 /? SE0/1/1 10.60.149.2 /? R2 Conestoga Waterloo SE0/1/0 10.60.148.1 /? SE0/1/1 10.60.147.2 /? R3 Conestoga Brantford SE0/1/0 10.60.149.1 /? SE0/1/1 10.60.148.2 /? from these.you can subnet further. octet 1 -10 octet 2-27 octet3- 0 Static routing is allowed