Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

Instructions: Read the scenario below, and use the concepts from the Small Business Subcontracting Limitations lesson reading and the policies and procedures from acquisition regulation

Instructions:Read the scenario below, and use the concepts from the Small Business Subcontracting Limitations lesson reading and the policies and procedures from acquisition regulation to answer the corresponding questions about small business set-asides.Unless otherwise stated, provide a citation to the exact reference in the FAR, DFARS, DFARS PGI, or CD where the information supporting your answer can be found.FAR, DFARS, and DFARS PGI citations must comply with the format requirements at FAR 1.105-2(c) and take the reader directly to the information supporting your answer.As appropriate, answers should refer to the applicable terms and conditions that would be included in the scenario contract.(20 points)

Scenario:You are the contracting officer for a requirement for commercial supplies with an estimated value of $425,000.The requirement is not in support of a contingency operation or a humanitarian or peacekeeping operation.The market research results for the requirement showed several potential offerors.The potential offerors were all deemed competitive in terms of market prices, quality, and delivery.The list of potential offerors included seven small businesses and four large businesses.

1.Will this acquisition be required to be set aside for small business concerns?

a.Yes

b.No

c.Not enough information

Reference:__________________________

2.Provide two examples of market research techniques that could be used by an acquisition team to determine the size status (i.e., large business or small business concern) of the potential offerors that may be able to meet the Government's requirement.A citation is not required for this question.

Answered

3.Which of the following clauses, if any, would be included in your contract that would place limitations on the contractor's ability to subcontract?Mark all that would apply.A citation is not required for this question.(4 pts)

a.FAR 52.219-6 Notice of Total Small Business Set-Aside (DEVIATION 2020-

O0008)

b.FAR 52.219-7 Notice of Partial Small Business Set-Aside (DEVIATION 2020-

O0008)

c.FAR 52.219-14 Limitations on Subcontracting (DEVIATION 2020-O0008)

d.FAR 52.219-33 Nonmanufacturer Rule

4.Assuming the prime contractor will manufacture a portion of the supplies, what is the maximum amount that it can subcontract to other than similarly situated entities (citation needed)?

Please only answer 4

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Dynamic Business Law

Authors: Nancy Kubasek

1st Edition

0073524913, 9780073524917

More Books

Students also viewed these Economics questions