IPv4 Static Routing 1. Using Cisco Packet Tracer (PT) already installed in your computer, simulate the inter- network depicted in the Figure below. Use the command line interface and commands described in the Appendix to configure the routers and achieve full reachability. 172.16.0.1/24 192.168.1.1/24 60-24TT SW3 2960-24T PC-PT Hostl Server-PT wwwi SW1 Fao/o Fa0/o 172.16.0.100/24 so/o/o so/o/o 10.12.12.1/30 10.12.12.2/30 192.168.1.100/24 Fa0/1 192.168.2.100/24 RT1 2811 Fa 0/1 RT2 172.31.0.100/24 1841 172.31.0.1/24 192.168.2.1/24 2960-24TT SW4 2960-24TT PC-PT Host2 Server-PT www2 2. Show the commands used to configure the static routes, for each router. 3. How many network segments are directly connected to each router? Show the network addresses 4. How many routes exist in the routing table of each router? Show a proof of your answer. 5. When analyzing the routing table in each router, how can you distinguish a static route from a directly connected route? Explain in your own words