LAN 2 is a wireless configuration. Each device is connected to an access point through a wireless network. This is a basic service set architecture, so there are no ad hoc wireless connections between devices. This networked system can use a single router connection between the access points and the Internet. However, between the access points and the router/gateway, install a switch and a network address translation (NAT) to convert IPv4 structured network to IPv6 encapsulated for transfer into the Internet via the router/gateway. The Smartphone devices must support both data and voice. You will need to use smartphone devices for the wireless connectivity because straight VoIP phones in Cisco do not support wireless; only PCs and smartphones. All of the internal network addressing is to be done by DHCP. The mobile devices do not support IPv6 addressing between the device and the access point. LAN 3 is a wired system that has a wireless router. Connect the three VoIP phones in series with the three computers. The three laptops are connected via the wireless router. Segregate the wireless router and the wired system phones/PCs using a switch. The internal IPv4 addresses need to be assigned via DHCP, however, the public IPv4 and IPv6 protocols are static. You will need a vlan. Run simulations that show connectivity among all the devices for the transfer of both voice and data. The architecture needs to include at least two servers that demonstrate the client/server exchange process for data. Run a simulation that shows the path for a VoIP phone call from a device within each of the networks to a device in each of the other networks. Run simulations that show and data voice connectivity among the LAN 1, LAN 2, and LAN 3 networks. Provide a screenshot of your network diagram and explain. Provide screenshots of your simulations in your test section of your paper.