looking for the commands in the boxes. which command would be used?

CCNAv7 (copy/paste) the contents of all tables into the matching tables in the CCNAv7 ITN Skills Assess Exam document for submission and grading. 2: Develop the IPv4 Addressing Scheme ven an IP address and mask of 192.168.22.0/24, design an IP addressing scheme that satisfies the following quirements. Subnet the address so that each subnet fits the network sizes (required number of hosts) therefore ubnets will use different subnet masks. Assign 0 subnet (192.168.22.0) to the largest network. ddresses Use Me! V10 F22 NOTE: Host computers will use the LAST host IP address in the subnet. The Network router will use the FIRST network host addresses of the subnetworl Each switch will use the SECOND network host address of each subnet. Complete the table below with the appropriate IP address information for each device. art 3: Configure IP IPv4 Settings Step 1: Configure host computers During the lab, you will screen capture the ipconfig fall on Netlab for each PC. You will need to record the Physical Address from the POD you use. Complete the table with the IP address information for each PC. Total pts: 47 Step 1: Initialize and reload router and switch (2 pts) The devices will automatically initialize when the Netlab Reservation is entered. If you were working in the lab.... What commands would you use? (Short cuts are OKI) Include the prompt at which the command will be run... >. \#. (config)H, (config-if) H. (config-line)\# Step 2: Configure R1 ( 19 pts) 1/2 pts will be earned here, 1/2 pts will be earned by configuration Include the prompt at which the command will be run.. (config) Step 3: Configure S1 ( 13 pts) 1/2 pts will be earned here, 1/2 pts will be earned by configuration Include the prompt at which the command wil be run... (config) H. (config-line) Step 4: Configure S2 ( 13 pts) 1/2 pts will be earned here, 1/2 pts will be earned by configuration Include the prompt at which the command will be run... (config) \#, (config-line)\#, (config-if) tt 5: Test and Verify IPv4 End-to-End Connectivity otal pts: 6 1: Verify network connectivity ( 6 pts) Ise the ping command to test connectivity between all network devices. Remember ping commands will not uccessful if configurations are incomplete or incorrect. These are the most common reasons after cabling. ou have the advantage using Netlab to know that your cabling is correct. Ise the following table to methodically verify connectivity with each network device. Do one at a time. PC-A cannot ping G0/1 there is no path to get to PC-B. Stop there and start troubleshooting. See the "Tips" elow. There should be at least TWO Reply lines from the address that you pinged indicating the byes and TI There should be NO Reply lines from any other address ... it is unsuccessfull If there is a message of "Destination Host Unreachable"... it is unsuccessful! ake corrective action to establish connectivity if a test fails. IX screen captures.... THREE from EACH PCs! Pasted into same Word document. Call it: pings. docx (lose 1 pt if incorrectly named) ubleshooting tips if pings are not working: erify addresses of all devices - start with the router, then the PCs, last the switches llake sure that the PC 's default gateway address matches the appropriate router interface. rerify that each switch's default gateway matches the appropriate router interface. furn Windows Firewall 'off on the PCs