Make use of the CCP Module and it's interrupt, to capture the timer value on every falling edge of RB3. When an interrupt occurs you must store the captured values in addres 0x20 and 0x21 of the EEPROM memory. Shown below is the second part of the interrupt service routine_Fill in the missing instructions and values. All values must be in hex (0x00) format. All unused pins must be outputs. Ox06 ADCON1 OX08 TRISB The timer must have a 1:8 prescale value and the main oscillator must be used as source. MOVLW MOVWF MOVLW MOVWF CLRF MOVLW MOVWF BCF MOVLW MOVWF MOVLW MOVWF GOTO END LIST #INCLUDE P=16F818 P16F818.INC TRISA OX04 PIE1 STATUS RPO OX01 T1CON OXCO INTCON MAIN ------ MAIN ORG GOTO ------ BCF MOVE BCF STATUS RPO STATUS RP1 CCPR1LW STATUS RPO STATUS RP1 MOVWF MOVLW MOVWF CALL BCF STATUS RPO STATUS RP1 STATUS RPO STATUS RP1 MOVF BCF BSF MOVWF MOVLW MOVWF OX21 WR_EE BCF WR_EE BSF BSF STATUS RPO STATUS RP1 EECON1 WR $-1 GOTO BCF EECON1 WREN MOVLW BSF BCF BCF EECON1, WREN STATUS RPO STATUS RP1 START MOVLW MOVWF MOVLW MOVWF BSF OX00 PIR1 OX04 CCP1CON STATUS RPO